Quantcast
Jump to content

Coleman Outfitter 800


Helodown66

Recommended Posts

I have been given a brand new Coleman Outfitter 800. I am a 100% Disabled combat veteran.

This UTV has been generously given to me and many other severely disabled via the Independence Fund and Wounded Warriors. First I wish to publicly express my appreciation to the Independence Fund for their generosity.

Having said that, now I have a few questions and request some help and direction.

This unit was delivered to my home about 30 days ago. I have read many of the comments directed towards these Chinese Knockoffs, and I would never go out and purchase one of these units. However, when you are given one, what can you say??

From the get go the braking system is marginal at best. Very soft and pedal has to be pushed very, very hard to bring unit to a stop. This is not acceptable for me. I have contacted Coleman PowerSports, in Tempe, AZ. They are of no help what so ever.

I have bleed the system twice to no avail, I am now ready to explore replacing the brake pads, rotors, and master cylinder, however, I do not and can not obtain part numbers! I have pulled the front wheels and inspected the front pads for contamination and/or glazing. Other than very Cheap carbon pads, the pads are not glazed one contaminated, however, extremely dirty with what I would call excessive brake dust, they appear to be OK.

Does anyone have any ideas as to replacement pads, rotors, and master cylinder??

Any constructive comments would be greatly appreciated as to what, where and who I can purchase correct fitting replacement parts including calipers, pads, rotors, and master cylinder.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Abermp
      I have a DesertCross 800 that doesn't want to stay in low, it pops out when I let off the gas. No problem with the other gears. What do I need to do?  Thanks.
    • By Robert B
      Going down a 20 deg hill engine is holding UTV back. Then something releases like going into Neutral and makes a loud clacking noise. Have to use brake to slow UTV down. Then once level it shifts back into gear. Have done shift extension does not pop out of gear.
    • By weasel
      starts up you have keep rpms up for 5 minutes till it warms up then runs fine. But if it stalls wont start unless you unplug fuel pump and hold it to the floor till it starts then plug pump back in and run it till it warms up then it is fine all day.
    • By Gary Odom
      I bought a tracker 88sx crew in 2023. It has a whishing noise coming from the front end. Starts out low and gets louder as speed increases. Took it back to the dealer and they said it was normal on this model. Any suggestions as to what may be causing this.
    • By amiracle40995
      I’m getting a 700-7 every startup. I’m having to change the plug every 100 miles on 93 octane gas. I got a lower numbered plug that is supposed to burn hotter. I’m wondering why that comes up every time I start it and if it’s related? I included a picture of the code or whatever it is. I haven’t seen the code in the owners manual or the hisun shop manual I have. 

×
×
  • Create New...