UTV Off-Road Classifieds - Buy & Sell

UTV Board Classifieds - List your UTVs or any other utility vehicles, parts, accessories, etc. Looking for something? Post it in this forum.

209 topics in this forum

    • 12 replies
    • 6,146 views
  1. DONE

    • 10 replies
    • 639 views
    • 10 replies
    • 4,800 views
    • 7 replies
    • 1,757 views
    • 7 replies
    • 404 views
    • 5 replies
    • 3,264 views
    • 4 replies
    • 1,100 views
    • 4 replies
    • 667 views
    • 4 replies
    • 219 views
    • 3 replies
    • 1,375 views
    • 3 replies
    • 2,472 views
    • 3 replies
    • 3,272 views
  2. Joyner Wheels and Tires

    • 3 replies
    • 3,936 views
  3. Mobius X8 Knee Braces

    • 3 replies
    • 173 views
    • 2 replies
    • 3,133 views
    • 2 replies
    • 2,625 views
    • 2 replies
    • 6,337 views
    • 2 replies
    • 1,558 views
  4. Low Milage Joyner T2

    • 2 replies
    • 1,469 views
    • 2 replies
    • 1,775 views
    • 2 replies
    • 1,484 views
    • 2 replies
    • 960 views
    • 2 replies
    • 1,856 views
    • 2 replies
    • 647 views
    • 2 replies
    • 722 views


  • Latest Posts

    • Mine is an 05 diesel. The only light that lights up before starting is the oil pressure light. Of course yours could be different. I think they went to some kind of onboard computer system soon after mine was built, but I don't know when. So yours could be a completely different machine. 
    • Need some ideas. the "left main bearing" in the crankcase, where the shaft sticks out, where the flywheel mounts, in the crankcase  it has a non replaceable bearing. If it is wore too much, you have to replace the entire crankcase. Im going to measure it later, (from a visual it doesn't look too wore) but i was wondering if i could buy a ball bearing and put in it IF it is wore past the service limit?
    • 5.5 and some change according to google.
    • Going to try to measure the rotor clearences on the oil pump. manual says: (Use feeler gauge)  Standard: Less than 0.14 MM  Service Limit: 0.3 MM and i cant find a  0.14 mm feeler gauge.  ????? i think, if my math is correct it comes out to .005?  5 thou?