Kawasaki UTV SxS Forum

This is for all of you Kawasaki UTV, SxS (Side by Side) owners. Discussions about Kawasaki specific topics including the Teryx and Mule models.

259 topics in this forum

  1. Muffler noise on mule 610

    • 3 replies
    • 664 views
  2. 2014 Mule 4010 gas

    • 2 replies
    • 609 views
    • 4 replies
    • 1,689 views
    • 4 replies
    • 466 views
    • 4 replies
    • 2,192 views
    • 2 replies
    • 65,349 views
  3. Mule 550 shocks

    • 2 replies
    • 1,446 views
    • 3 replies
    • 751 views
    • 1 reply
    • 1,167 views
    • 2 replies
    • 1,203 views
    • 2 replies
    • 906 views
  4. PastorBob

    • 1 reply
    • 240 views
  5. 1997 Mule 2510

    • 3 replies
    • 341 views
    • 1 reply
    • 617 views
  6. Wheels

    • 0 replies
    • 516 views
    • 3 replies
    • 546 views
    • 1 reply
    • 379 views
  7. mule cv boot

    • 3 replies
    • 424 views
    • 0 replies
    • 467 views
    • 0 replies
    • 458 views
    • 1 reply
    • 1,111 views
  8. Taller tires or a lift for my mule 4010?

    • 10 replies
    • 19,965 views
  9. 2010 starter

    • 0 replies
    • 376 views
    • 0 replies
    • 1,480 views
    • 1 reply
    • 1,537 views


  • Latest Posts

    • Mine is an 05 diesel. The only light that lights up before starting is the oil pressure light. Of course yours could be different. I think they went to some kind of onboard computer system soon after mine was built, but I don't know when. So yours could be a completely different machine. 
    • Need some ideas. the "left main bearing" in the crankcase, where the shaft sticks out, where the flywheel mounts, in the crankcase  it has a non replaceable bearing. If it is wore too much, you have to replace the entire crankcase. Im going to measure it later, (from a visual it doesn't look too wore) but i was wondering if i could buy a ball bearing and put in it IF it is wore past the service limit?
    • 5.5 and some change according to google.
    • Going to try to measure the rotor clearences on the oil pump. manual says: (Use feeler gauge)  Standard: Less than 0.14 MM  Service Limit: 0.3 MM and i cant find a  0.14 mm feeler gauge.  ????? i think, if my math is correct it comes out to .005?  5 thou?