Quantcast
Jump to content

Arctic Cat UTV SxS Forum

This is for all of you Arctic Cat UTV, SxS (Side by Side) owners. Discussions about Arctic Cat specific topics including the Arctic Cat Prowler, Wildcat, Wildcat Sport, Wildcat Trail, Wildcat X, and all sub models. 

23 topics in this forum

    • 0 replies
    • 799 views
  1. Artic Cat Parts

    • 2 replies
    • 1,484 views
    • 0 replies
    • 644 views
    • 4 replies
    • 3,982 views
  2. Wildcat

    • 29 replies
    • 4,257 views
    • 0 replies
    • 2,610 views
    • 1 reply
    • 1,830 views
    • 0 replies
    • 1,777 views
    • 2 replies
    • 3,692 views
    • 6 replies
    • 4,914 views
    • 3 replies
    • 5,654 views
    • 1 reply
    • 2,911 views
  3. New Toy Project

    • 3 replies
    • 3,181 views
    • 5 replies
    • 4,441 views
    • 6 replies
    • 3,511 views
  4. Arctic Cat at Sema

    • 1 reply
    • 2,909 views
  5. Amazed

    • 2 replies
    • 2,657 views
    • 0 replies
    • 2,210 views
    • 0 replies
    • 2,343 views
    • 0 replies
    • 2,243 views
  6. Finally Done

    • 8 replies
    • 4,516 views
  7. Second Battery

    • 4 replies
    • 3,647 views
  8. Come On People!!!!

    • 9 replies
    • 4,810 views


  • Latest Posts

    • Well, I know a little about these clutches. are you still having issues with them? And if so, what is happening to the wet clutch. and second, are you having any issues with the outer clutches at all? When you replaced the clutch, did you use an OEM clutch or an aftermarket one? Did you replace the one way bearing as well. and when you replaced the clutch, did you replace the outer clutch drum? Matt
    • no one has gotten back to me  
    • Sounds like a good deal! I would find out if there is a undersized rod, and specs for grinding the crankshaft, that *might* be cheaper than having to get a new rod and crankshaft, possibly.
    • As far as I know you would need to take that nut off of the very end.
    • Hi Travis!  I think they ran it out of oil. Even though there is fresh oil in it now.  Has only 338 hours on it.   Mentioned a rod knock and-  that they kept using it. I bought it from a guy that works in construction.  Didn't get too hot at least.  It turned over, but makes clunk noises, when I get the side cover off,  the evidence will likely fall into my lap.    Paid $1500 for it, seemed like a deal for what we need it for.  Just hoping I can salvage what wasn't destroyed.  May swap in a Vanguard twin if I need to.  I have built many mower and ATV engines over the years, but never this setup. 


×