Quantcast
Jump to content

UTV News and Information

UTV News brought to you from UTV sources such as sidexsideaction.com

466 topics in this forum

    • 3 replies
    • 1,615 views
    • 0 replies
    • 661 views
  1. Polaris Oil change kit

    • 0 replies
    • 304 views
    • 0 replies
    • 1,109 views
    • 0 replies
    • 631 views
    • 0 replies
    • 691 views
    • 0 replies
    • 715 views
    • 0 replies
    • 905 views
    • 0 replies
    • 509 views
    • 0 replies
    • 705 views
    • 0 replies
    • 656 views
    • 0 replies
    • 488 views
    • 0 replies
    • 510 views
    • 0 replies
    • 637 views
    • 0 replies
    • 523 views
    • 0 replies
    • 583 views
    • 0 replies
    • 757 views
    • 0 replies
    • 736 views
    • 0 replies
    • 550 views
    • 0 replies
    • 661 views
    • 0 replies
    • 542 views
    • 0 replies
    • 582 views
    • 0 replies
    • 650 views
    • 0 replies
    • 505 views
    • 0 replies
    • 942 views


  • Latest Posts

    • Wow, thanks for all the great references. I will let you know what I find in a couple weeks.
      Cheers  
    • She's a runner!  Waiting on some special tools to get here as I have some tuning to do on the clutch. Clutch stalls the motor a bit high, so I have a feeling it's all caked with mud in the clutch sliders.  Runs good though!   
    • Stuck float should be easy. locate the carb, take off the bowl, (bowl nut on carb, ) the float should be level, not hanging down.   fuel pump: Pretty much, just replace it. They don't make any repair parts for them.   Found this thread reply on another forum, seems to be a common problem with the 610  a dirty carburetor...or a bad float ...or a bad inlet needle.   What is happening is that the gasoline is bypassing the float needle and is overflowing. Then it goes through this passageways and into the oil pan.   IF there is dirt that has gotten onto the needle or seat, this will hold the needle open.   If there is a small hole in the float, then the float will sink allowing too much gas to enter the carburetor. causing this problem.   If the needle or seat has worn or has a chip in it, then the gas will bypass them and flow into the oil.   This is a very common problem.   ALSO, if you have a vacuum operated fuel pump, the diaphram inside the pump may have gotten a hole in it. This will allow gasoline to pass through the diaphram and into the oil supply.  
    • Don't know if this will help, but it looked interesting, and possibly relevant. If you end up finding that the fuel pump is the problem. I'm not sure what obstacle the poster ran into that made him go this way, instead of an actual repair. But sometimes there's little choice. But until we know what the problem is, this is a cheap alternative, and a quick fix. If it's a stuck float, a fuel cut off is always a good idea anyway. And it'll stop that particular issue. Although it won't actually fix the real problem, it'll stop the unwanted gas.
    • Travis, any advice on how to check for these conditions? I'm not much of a mechanic but a fast learner.


×