Hisun UTV SxS Forum
This is for all of you Hisun UTV, SxS (Side by Side) owners. Discussions about Hisun UTV specific topics including Sector, Strike, and HS models.
489 topics in this forum
-
- 6 replies
- 265 views
-
- 8 replies
- 366 views
-
- 4 replies
- 4.7k views
-
- 4 replies
- 493 views
-
- 0 replies
- 148 views
-
- 8 replies
- 4k views
-
- 2 replies
- 479 views
-
- 3 replies
- 255 views
-
- 4 replies
- 314 views
-
- 6 replies
- 713 views
-
- 4 replies
- 397 views
-
- 4 replies
- 428 views
-
- 2 replies
- 317 views
-
- 17 replies
- 13.9k views
-
- 3 replies
- 569 views
-
- 2 replies
- 271 views
-
- 12 replies
- 8.9k views
-
- 16 replies
- 9.6k views
-
- 2 replies
- 453 views
-
- 0 replies
- 238 views
-
- 3 replies
- 3.2k views
-
- 5 replies
- 2.9k views
-
- 4 replies
- 551 views
-
- 2 replies
- 585 views
-
- 3 replies
- 490 views
-
- 1 reply
- 539 views
-
- 0 replies
- 6.7k views
-
- 0 replies
- 511 views
-
- 0 replies
- 596 views
-
- 9 replies
- 6.4k views
-
Latest Posts
-
By Joe Breaux · Posted
DO NOT BUY MASSIMO OR ANYTHING HISUN... you have been warned. You will regret it. They are Chinese junk.. -
By Clyde says · Posted
I have a 2014 landmaster S/S 4x4 model 653 4x4 with a 22 hp robins engine. I've been having problems with the govenor reving after it running a short distance. I cleaned the carb and discovered the fuel membrane has a slight pin hole (P/N 210-253). Can not seem to locate a replacement. Any suggestions? It appears this carburetor is no longer supported. -
By Joe Breaux · Posted
I run screaming at the mere mention of the word HISUN....I had a nightmare of problems with mine ,beginning on it's first day.and got zero help from Massimo in TX or HISUN in China -
Hey all. Just thought I'd weigh in with our pretty much horrible experience with a new Axis 700 purchased last May 2023 from Lowes in Winchester, VA. Brought it home, put about 10 hours on it and it won't hold a charge. LOOOOONG story, the mobile tech has been out 4 times, replaced the battery, voltage regulator twice. I told him in February I thought (after doing a bit of research) that it was the stator, since if kept on the trickle charger it reads 100% charged, run it 15 minutes and it's down to 40%-that means the stator is not charging the battery while it's running. Anyway, last time he came out the part that he was supposed to change out was shipped in too small a package and was bent and unusable. I have about a 10 page email chain to 6 different folks at Hisun in TX begging for some resolution. They ignore my calls, emails, voice mails, etc. Needless to say, we are really frustrated with the vehicle, the company, the mechanic; pretty much everything to do with this worthless POS. It is truly ridiculous to spend $10K on something that is now sitting in our garage torn apart waiting for the worthless mechanic once again. -
By Jerry_Axis500 · Posted
Follow up on my issue. I took it to a HISUN certified repair shop and it took these guys 3-4 hours of troubleshooting to figure out what was wrong because it was sporadic (I get it...if you can't get consistency with the issue and recreate it, it is hard to diagnose). The issue with mine was an obvious QA issue from the manufacture (I only have 100 miles on it). The plug for the fuel injector power was not plugged in all the way so sometimes it worked and other times it didn't.
-
