Quantcast
Jump to content

UTV General Discussion

UTV Side by Side General Discussions Forum. Please post UTV related topics in this forum only.

234 topics in this forum

    • 3 replies
    • 342 views
    • 1 reply
    • 92 views
    • 2 replies
    • 65 views
    • 0 replies
    • 44 views
    • 5 replies
    • 175 views
    • 0 replies
    • 86 views
    • 3 replies
    • 95 views
    • 0 replies
    • 115 views
    • 0 replies
    • 133 views
    • 3 replies
    • 161 views
    • 6 replies
    • 1,136 views
    • 2 replies
    • 341 views
    • 4 replies
    • 197 views
  1. cub cadet 750

    • 6 replies
    • 169 views
    • 0 replies
    • 87 views
  2. Steering hard

    • 5 replies
    • 166 views
    • 0 replies
    • 170 views
    • 5 replies
    • 165 views
  3. Wet Pro FXT

    • 1 reply
    • 126 views
    • 0 replies
    • 106 views
    • 0 replies
    • 145 views
    • 2 replies
    • 145 views
  4. UTV Cover

    • 1 reply
    • 152 views
    • 1 reply
    • 138 views
    • 5 replies
    • 216 views


  • Latest Posts

    • I have a Joyner cammando 650cc but I need a spiral bevel gear rear and pinion. I'm unable to locate any. Mine is stripped and only front wheel pull  do you know where I can get one?
    • Glad to see theres some more out there when i was looking for mine it seemed like it was a hard to come by item, joyner told me the one i bought was the only one they had left.
    • The YouTube video says the top of line configuration for this ride is about $62,000.
    • UPDATE: I've been so dang busy lately, i finally got a couple of hours to work on the jacka$$... i mean Mule..😉 Got the rod bolts torqued, pulled off the oil pump/tang installed the cam and timed it it to the crank, put the cover on, and for those who dont know or remember the ordeal with the crankshaft and cover: There is a  shim between the crankcase cover and the crankgear, this helps control the end play, or side to side movement of the crank. anyway, the first time i installed the cover the crankshaft would not spin by hand (according to the manual its supposed too)  so i measure all the clearances  (according to the manual instructions) and came up with the correct size shim. so back to TODAY.  I installed the new  shim (VERY easy)  slid the cover on, put the new bolts in, torqued them and the moment of truth,  the crankshaft spun by hand,which is what i was looking for!  So now all i need to do  is install the head and set the valve clearance. and for anyone else rebuilding any engine,  i do not recommend using Permatex  assembly lube, it is  very slick and not tacky, it runs of the parts easily, so i bought some Lucas lube, and it's slick, but tacky enough it held onto the  surfaces. https://www.amazon.com/Lucas-Oil-10152-Assembly-Lube/dp/B000WJ3M6I  


×