Quantcast
Jump to content

UTV General Discussion

UTV Side by Side General Discussions Forum. Please post UTV related topics in this forum only.

211 topics in this forum

    • 0 replies
    • 6 views
    • 0 replies
    • 9 views
  1. UTV Survey

    • 3 replies
    • 244 views
    • 2 replies
    • 203 views
    • 2 replies
    • 104 views
    • 0 replies
    • 86 views
    • 5 replies
    • 218 views
    • 0 replies
    • 201 views
    • 1 reply
    • 221 views
  2. Frog Pond Pug

    • 4 replies
    • 785 views
    • 3 replies
    • 313 views
    • 1 reply
    • 158 views
  3. UTV back end weight

    • 1 reply
    • 279 views
    • 2 replies
    • 243 views
    • 0 replies
    • 169 views
    • 20 replies
    • 1,011 views
    • 0 replies
    • 288 views
    • 5 replies
    • 667 views
    • 0 replies
    • 321 views
  4. Winches

    • 1 reply
    • 176 views
    • 5 replies
    • 315 views
    • 2 replies
    • 239 views
    • 0 replies
    • 472 views
    • 1 reply
    • 282 views
    • 7 replies
    • 323 views


  • Latest Posts

    • I'd move the bug-eye headlights to the front and below the hood line as they are on the newer model Troopers.  Then put turn signal lamps were the headlights were.  Other than that, what you have looks real sharp.
    • I have a 2012 Kawasaki 4000 Mule and the hood release cable is frozen and will not move. I want to replace the cable and have removed the fenders, hood, cargo box to access the cable. I finally had to remove the plastic dash far enough away so I could get a wrench on the nut holding the cable release knob in place. That's a lot of fun. I cannot remove the pin holding the cable to the release bar mechanism. Is that a force fit pin or what. There are no keepers holding it in place. Any suggestions on how to get the cable out? I can see why the previous owner never fixed it as you have to remove the whole front to get to the cable. I've tried penetrating fluids to make the cable work with no success. Your help is appreciated. Gerry C.
    • I have a 2012 Kawasaki 4000 Mule and the hood release cable is frozen and will not move. I want to replace the cable and have removed the fenders, hood, cargo box to access the cable. I finally had to remove the plastic dash far enough away so I could get a wrench on the nut holding the cable release knob in place. That's a lot of fun. I cannot remove the pin holding the cable to the release bar mechanism. Is that a force fit pin or what. There are no keepers holding it in place. Any suggestions on how to get the cable out? I can see why the previous owner never fixed it as you have to remove the whole front to get to the cable. I've tried penetrating fluids to make the cable work with no success. Your help is appreciated. Gerry C.
    • how about how to get the race and cage off the inner front cv shaft, i dont see a snap ring anywhere?
    • silvebullet.We do sell a complete kits.Drill a few holes and you are done.silverbulletmotorsports.net 928 344 2117  


×