New Members Area
Are you a new member to UTVBoard.com? Stop by here and introduce yourself. Tell us about yourself, your vehicle, etc.
304 topics in this forum
-
- 1 reply
- 172 views
-
- 0 replies
- 282 views
-
- 0 replies
- 215 views
-
- 3 replies
- 302 views
-
- 0 replies
- 2.7k views
-
- 0 replies
- 319 views
-
- 0 replies
- 560 views
-
- 0 replies
- 424 views
-
- 0 replies
- 421 views
-
- 8 replies
- 900 views
-
- 0 replies
- 635 views
-
- 1 reply
- 610 views
-
- 4 replies
- 620 views
-
- 0 replies
- 646 views
-
- 0 replies
- 474 views
-
- 0 replies
- 608 views
-
- 0 replies
- 710 views
-
- 0 replies
- 875 views
-
- 4 replies
- 871 views
-
- 1 reply
- 1k views
-
- 0 replies
- 769 views
-
- 0 replies
- 759 views
-
- 0 replies
- 749 views
-
- 0 replies
- 719 views
-
- 0 replies
- 788 views
-
- 1 reply
- 802 views
-
- 0 replies
- 940 views
-
- 0 replies
- 912 views
-
- 1 reply
- 1.3k views
-
- 1 reply
- 1.2k views
-
Latest Posts
-
By Ron from the Mitten · Posted
I purchased a 2008 Qlink Rodeo 700 a few years ago. I am from Michigan. Anyone know of any local repair shops? I had a dead battery, so I replaced that, started right up, ran the quad down the road, (this was last year), put it in the barn, shut it off. then a couple weeks later, went to go start it again, and nothing. I have power to the dash lights, horn, turn signals, wench etc, but nothing to the starter switch, and I hate electrical crap. Battery still reads 12.x volts. Any suggestions would be amazing. I've owned it over 2 years, and haven't run 1 tank of gas through it. No time to screw with it, and very frustrated. Hoping someone can offer some advice of value. -
By "small body tank" do you mean carberator bowl? If so you might have a fuel pump issue. I'm not familar with the carbed models do they have an electric pump? have you tested the pressure on the fuel line? is there an inline filter? -
Interesting, I have heard of a few on cars where they fail once hot. That's not where my mind would have taken me troubleshooting. Glad to hear you've fixed it!
-
I wasn't able to verified for spark but it acted the same way. I read on car forum about the crank position sensor causing the same issue as what I seen on my UTV. Since the part is not that expensive and difficult to get to, I went ahead and replace them anyway. Once that replaced, everything work fine and the engine seem to be a little more responsive and less noisy as well. We took it out a few more times for couple trips over an hour ride at the time. No problem so far. -
View File Hisun HS400/Coleman UT400 Parts Diagrams Compiled document with parts diagrams for Hisun HS400/Coleman UT400 for help in repairs where the service manual diagrams are poor or non existent. Submitter aefron88 Submitted 04/15/2024 Category Hisun
-
