Quantcast
Jump to content

pebaugh

Members
  • Posts

    2
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

pebaugh's Achievements

Newbie

Newbie (1/14)

  • First Post
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. I have a covered trailer which is 77.6" tall at the entrance and 82" inside. The issue is that I have an opportunity to get an early build 2023 KRX4 1000 eS special edition with a roof. Without a roof it is 76.2"H yet with the roof it is 79.3" H. It appears the only way I will be able to get this in the trailer is to remove the roof. My main question is how much effort does it take to install and remove the roof? I assume that other than the longer size, this should be the same as the 2 seater. Can any two seater owners weigh in on this? I am hoping that with two people it is a 5 minute job.
  2. I am in the process of ordering a 2022 General XP4 1000 Deluxe and request some guidance on widths for an enclosed trailer. Since this is a 64" wide machine, Ideally I would like to get a 7 1/2' width trailer which would get me 26" total clearance on the sides. If I drive the machine to the right side I could have as much as 2' on the drivers door side. The problem is that 7 1/2' trailers are not as plentiful in the market (new or used) as the 7' or 8' wide trailers. I would prefer not to go as wide as an 8' due to sight concerns. For a 7' wide trailer I could have up to 18" of clearance on the drivers side for ingress and egress. For those of you with 7' wide trailer, are you good with the amount of space you have to get in and out of the drivers door without climbing out the back of the machine? The machine is 12 1/2' long so I am planning on getting a 14' or 16' long trailer. Any guidance there? I appreciate all comments. thanks.
×
×
  • Create New...