Quantcast
Jump to content

moparman48081

coleman 500 outfitter wont turn over

Recommended Posts

i have a coleman 500 outfitter 

engine will not turn over by using the ignition but will when you jump the starter silenoid 

also when it is running using this the battery is not charging 

i have replaced the ignition and starter sileniod still no difference 

near the passenger side wheel well area there was a wire with a plug that had a plug with resistor on it and the resistor is fried i havent been able to figure out a replacement part for it 

im hoping someone has some ideas on this 

20180928_113744.jpg

Share this post


Link to post
Share on other sites

That appears to be a diode.  Can you see any labeling that might start with "1N".  That signifies a diode and no a resistor.  I'll see if I can find something online about it.  But maybe another Coleman owner or dealer can ID the part in the meantime.  A website I visited said that the Coleman may be a rebranded Hisun UTV.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Forum Topics

    • Pug battery post melted

      I noticed the battery post was melted when the pug wouldn't start... With the pug off, just placing the cable back onto the battery creates tremendous Heat with in 5 seconds or so... I had just taken off all the connections and clean them with a wire brush just a few months back...Including battery cables and wires for the starter solenoid.  Could this only be a short or bad connection or is there something else?..could the cells of the battery be doing this or maybe the rectifier/regulator? The rectifier from visual inspection doesn't seem to be melted or discolored!

      By Doc Holland, in UTV General Discussion

      • 1 reply
      • 100 views
    • Wiring problems with 2014 Coleman Outfitters Utv(Hisun) 400 4x4

      Hello all, I have what I hope is a quick question. I am working on this 2014 Hisun SxS and the wiring is a mess. I am currently just trying to find the electrical wiring Color Code for this machine. I have Maintenance Handbook for a wiring diagram for what it calls a 'HS400UTV-Emark'. That's the only thing my son got with this machine when he bought it and I can no list of the color codes anywhere in this book. We're not against buying manuals but have learned to be picky as there are many that supply little real detailed information. This is a machine that I am trying to get the 2004 Kodiak motor they installed wired up to run and install a complete new wiring harness for the Utv at the same time. Any help that someone might have to offer would be greatly appreciated. Thank you all and I hope you all had an enjoyable Thanksgiving holiday.

      By res2fr, in Hisun UTV SxS Forum

      • 3 replies
      • 103 views
    • Second Battery

      I am installing a second battery in my 07 Prowler. How do I wire it up so the stereo doesn't drain the main battery, but the second battery can still charge

      By Blaze379, in Arctic Cat UTV SxS Forum

      • 4 replies
      • 3,498 views
    • Polaris Ranger 800 11-16 4x4 6x6 Crew Engine Motor Rebuilt

      Polaris Ranger 800 11-16 4x4 6x6 Crew Engine Motor Rebuilt On Ebay https://www.ebay.com/itm/Polaris-Ranger-800-11-16-4x4-6x6-Crew-Engine-Motor-Rebuilt/361534749653?  

      By johnpeter, in UTV Off-Road Classifieds - Buy & Sell

        
      • 0 replies
      • 246 views
×