Joyner 650 commando rear differentail and its parts are avaialbe now.
Qty is limited. Any one who is in need please contact [email protected]
By Scott Meszaros
good morning, new to this site...got a question......i have a 2015 kaw mule with the soft top enclosure........doors with zipper windows, plastic windshield.........i want to tow the thing on a trailer up to our cabin, about 340 miles of mostly interstate driving......the instructions for the top say "remove for towing or use enclosed trailer"..........removing would be a pain, and i don't have an enclosed trailer..............anyone have another solution?.........how much will it screw it up if i tow as is?.....should i put a plastic tarp over the thing and secure the tarp to the trailer?......any suggestions would be helpful.....thank you in advance
Just bought a well used 2500 with 6,800 hours on the clock. Guy said it had a bad engine but it did run and drive when I tested it and it billowed white smoke. I found oil in the water and a disconnected fan switch. A compression test yielded 160 psi in one cylinder and 240 psi in the other. I put 15 psi in the cooling system and it dropped to zero in 30 seconds. I removed the spark plugs and put 100 psi of air into each spark plug hole and coolant few out of the uncapped radiator. So I figured I had two bad head gaskets.
I took the heads of the engine and found two bad head gaskets. Cleaned them up, checked for cracks, found none and reassembled with new genuine Kawasaki head gaskets. Started engine and it ran well but smoked constantly at idle and at full throttle. Comprression test now yielded 240 psi and 245 psi which is higher than I have ever seen in any gasoline engine I have ever tested. I put 100 psi into each spark plug hole and no water or air bubbled out of the open radiator cap. When I put 15 psi into the cooling system it held pressure. Also fixed the fan switch connection and installed a digital temperature guage so I know exactly what temperature the engine is seeing and that the thermostat and cooling system is functioning properly.
The engine smokes like it is worn out and needs overbored but with those great compression numbers it is had to believe. I am ready to pull the engine and tear it down but thought I would post to this forum before I did.
This is my first Mule. I only paid $800 for it and might decide to just part it out depending what I find inside the engine. Brakes are good, trans works fine and there is almost no rust anywhere.
Any advice will be greatly appreciated.
By Dale Linton
Hey guys new to the forum! Upgraded my old 800 to a 900s and decided to part out my 800. Have a few items laying in the garage and didn’t know if they could get someone back on the trail!!!! I have..
good rear end
and good secondary clutch
all parts came from a 2011 rzr 800 with 1800 miles. Have pics of odometer and video of it running .thanks for looking