My ol mule is acting up suddenly. It doesn't want to idle, it revs prefect just not idle. It eventually dies. I'm thinking something in The idle passage is plugged. Any other suggestions are appreciated that I may have over looked.
Brand new Wix fuel filter. That carb has been on for 19 years and never cleaned. Just b12 chemtool in the tank. I may hook up an auxiliary tank and see if it's fuel lines. But probably not since it revs fine.
Hey folks. I recently acquired a pre-owned Hisun 500, carburated. And surprise... it has issues.
When cold, it typically starts without any issues, but once it warms up it tends to sputter and stall out. When accelerating, you can also feel it hesitating occasionally, and when you stop or put her into reverse, she will often stall. The fuel is clean, I installed a new fuel filter, and the air filter is clean. Though the fuel pump appears to be working ok, it makes a strange knocking sound whenever power is put to it. I've never heard anything like it, and I'm not sure if its shot or just a cheap Chinese pump thing. I have an aftermarket pump coming, and I've ordered a new ignition coil as well on the off chance that it is faulty. I am hoping replacing these two parts will solve the issue, and if it does I will post the results here.
If not, anyone have any other ideas? Also, I've noticed it is very difficult to find parts for this make... any suggestions on a good source for Hisun parts? I appreciate any comments or insights.
hi. i got a 2017 warrior 700 . fuel injected, suddenly it wont idle, wont start unless i press peddle then it starts with clutch engaged, i can tell the cicuit aint working for idle maybe fuse. ordered manual from sc autosports, taking its sweet time , dont know were anything is , is there a fuse block or something, anyone familier with the fuel injection on them things
By Robynne Catheron
New-to-me 2012 CC Volunteer throttle cable broke during the wicked cold snap we had a few weeks ago (upstate NY). It was already a bit sticky, but at least it was usable.
Is it possible to replace it myself, or must I pay to have it hauled 50 miles to the nearest shop? I can access both ends, but the majority of it is pretty buried from the top and underneath.
Any advice would be appreciated.
By Lance Respess
Hi I'm new here, got a hysun 750 my Pop bought about 8 months ago. The throttle got to where when you would stop it would be idled up a bit still pulling and you could pat the accelerator and it would idle back down to normal, did that the other day and the thing went wide open and is still stuck wide open. Have exhausted all my mechanical know how. Any ideas? Thanks