Quantcast
Jump to content

akbatj

2017 Can Am Commander Max XT 1000 Lift Kits

Recommended Posts

2017 Can Am commander max xt 1000 . Lookin for suggestions for a good lift kit

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Joe Breaux
      Got a 2017 Massimo MSU500 UTV with thermostat malfunction.. hot light comes on in 4-5 minutes but radiator is ice cold... where exactly is it?  The hose neck on the head has nothing in it.  I was told it was down by oil drain plug.. only thing I see is water pump.. Is in inside pump housing?  Cant find any exploded diagrams that show it.. how to I remove it? any help would be appreciated
    • By Jon
      Had this UTV 1 week now, previous owner had put windshield and back window on, has half doors but no windows.  Is there a simple fix for exhaust fumes in cab, tailpipe extension etc?    Thx so much.   Jon
    • By johnpeter
      2015 Polaris RZR XP 1000 eps On Ebay
      https://www.ebay.com/itm/2015-Polaris-RZR-XP-1000-eps/283999525191?

    • By Kevin Heihn
      Is there a difference in the body parts. They look the same. I need parts for my 2017 but the only parts available are for 2019/2020. Dominator 1000 5 seater.
    • By dalerio007
      i have a 2017 cub cadet challenger 750 camo, after a month of nonstop work with the pandemic i was finally getting a chance to ride it. it would not start, the battery was dead, went to charge the battery and noticed a mouse had chewed a yellow wire one of2 going to a block of some kind in battery box, it is tied into the 2 fuse relay breakers  attached to the starter relay. there is a red with stripe wire that goes to a harness below the rectifier in engine compartment, it has no power to it with multimeter and the fuse block is getting real hot. other than that the dash lights up, but no readout and the gauges dont cycle, the fuel pump does not start. on the fuel pump i checked the red wires to the cdi and both have contact and are intact but one does  not have power when the key is on and there is no spark  i tried starting fluid. i have swapped out the cdi from my cousins  same year and model, also the ecu and the main relay. i have no idea where to look now. his has broke the shim again and will not start. also i did notice that i wiggled a wire connector going to a sensor on the engine and a couple lights came on on the dash, the stirring wheel one and check engine but only did it once and i cant get it to do it again. i have looked over the harness for anymore damage and have found none.
      has anyone seen this problem before, is it wiring? ground? what do i need to check next. the place i bought it has no service the guy said he could only swap parts and try. sent me to another place over an hour from me  and that guy on the phone said he was covered up and didnt know when he could look at it so he must be busy lol. besides i dont want to have them charge me $3000 to replace everything on it before they get going.
      my advice is do not buy a cub cadet, we thought we were getting a cub cadet and it turns out it is a cheap chinese pos. i still love my cub but wish i had known this before i bought it and i would not have.
      any help would be appreciated thanks
  • Similar Tagged Content

    • By Lucas King
      This is all new to me, I have never been on a forum site before but thought this would be a good time to start. I have an opportunity to buy a 2011 cam am commander 800 xt.  It is yellow (which I don’t love;)) with 155 miles on it.  It came for the DRP factory in Texas where it was used to go from plant to plant. I can pick it up for $6900.  This would be used on a farm mostly.  Not looking to start a war on what machines are better, just wanting to know if this is worth it.
       Thanks 
    • By strike250
      Here is our test mule, with our 2" lift kit, our exhaust system, and some lighting. We have also taken this down to the frame and removed every single nut and bolt. We have done a lot of R&D on this UTV. Please feel free to ask us any question regarding it. Thank you. Matt
    • By strike250
      Hello there, We are doing some serious R&D on the Hisun Strike 250. We currently have a 2" lift kit available, exhaust system, clutch replacements, and advice like no other. We have taken this unit down to the frame and replaced almost every nut and bolt. So we know this UTV. Please feel free to ask any question about this and it's sister units UTV's.
      We have complete clutch OEM assemblies available for $ 199 for both items, compared to the factory of 190+156 for both items. (plus shipping)
      We have brake pads available for $19.99 front or rear per wheel.
      We have CV belts available for $99.99 (plus shipping) currently out of stock, but back soon
      We have 2" lift kits available (bolt in!) for only $79.99 ( plus shipping)
      We have exhaust systems available for $249.99 (plus shipping) currently back ordered so get in line!!!
      Advice is always free!!!!!!!
      We will have our website up and running next week.






    • By 08trooper
      So i am new to this forum, but im sure im not the only person wanting to lift their trooper. If anyone can help it would be much appreciated. If not i will fabricate it myself and will be sure to post pics.


×
×
  • Create New...