Quantcast
Jump to content

mtarallo

Members
  • Posts

    2
  • Joined

  • Last visited

Posts posted by mtarallo

  1. In case anyone stumbles across this thread, apparently the "new" starter relay I got from Autozone wasn't compatible or it was defective. So I found a exact match, 056700-5260 Denso Heavy Duty Relay for $7.13. Note: the same relay found from other parts places on the internet, sells for $37+ so shop around first. Hope this helps someone who may have the same issue.

    2u4iu7a.jpg

    • Like 1
  2. Hello All, thanks for looking at my situation. I am new to the UTV world, but not small engines. Hoping you can help and I thank you in advance for your support / suggestions. My neighbor gave me his old 550 mule, which needed some TLC.

    It is a late model 2003 or earlier Kawasaki Mule 550, not sure of the VIN as I cannot locate it, and then did re-paint / powder-coat it. However I was able to get the right new parts as they matched the old ones.

    • I have replaced the entire electrical chassis wire harness (headlights to tail light)
    • Brand new battery
    • new starter relay
    • same voltage regulator - not sure if this has failed - may need to test resistance
    • battery reads 12.8 volts
    • start and solenoid work
    • note sure about the Neutral Safety Switch - I pulled it, (light green wire from harness attached) - what appears to be drop of oil on tip.

    After I take the battery tender off the Mule, turn the key it starts up just fine and runs well. After using it for sometime or letting it run, after I shut it off, it will not start again via the key. I turn the key and nothing, no clicking, dimming of lights, nothing. It is as something i is blocking the starter trigger wire. If I remove the starter relay and test for voltages I get 12 volts on 1 prong and about 1 volt or so from the starter trigger wire (red / black) - if I turn the key, that wire registers 12v. If I jump the blades and turn the key - it starts no problem / every time.

    This also works, with the starter relay plugged in, if I turn the key and touch the metal top of the relay on the chassis , you will here the starter clicking and engage and eventually it will start. I find this odd as it started this morning, cold with no issue.

    • Is it a bad brand new relay?
    • a bad regulator?
    • the NSS?

    I am drawing a blank, I called a few guys I know over at the local power sports service center and they could not think of anything.

    Thanks for your help

    Mike

×
×
  • Create New...