Quantcast
Jump to content

Podunktoo

Members
  • Posts

    1
  • Joined

  • Last visited

Podunktoo's Achievements

Newbie

Newbie (1/14)

  • First Post

Recent Badges

0

Reputation

  1. Hi Charles, I'm new here too. We picked up a used 2006 like you and recently had problems with engine revving ok, but no vehicle movement. After finally getting the cover loosened so I could see belt between drive pulley and driven pulley, I finally found that the bolt and keystock had come out of the driven pulley. I had to remove the tire on that side in order to see into the hole to find that parts had shifted and keyway was no longer lined up to allow keystock to be put back in. I haven't been able to get it back into alignment and none of the manuals I have found mention anything about it. We have no Land Pride dealers around so I'm at a loss as to how to get it fixed. I'm not impressed with the manufacturing design of this vehicle. The pulley cover can't be removed completely because of insufficient clearance. A sheet metal panel must be removed to get the pulley cover off. Nuts should have been welded in place at mfg. Screws holding the sheet metal panel in place are located behind 1" wire bundles that do not allow box end wrench or sockets to get onto the nut and insufficient clearance to allow a ratchet to move. I'm sure that helped keep their maintenance shop funded by additional labor hours required for repairs. Any suggestions for repair would be much appreciated. Thanks, Tom
×
×
  • Create New...