Search the Community

I purchased a 2008 Qlink Rodeo 700 a few years ago. I am from Michigan. Anyone know of any local repair shops? I had a dead battery, so I replaced that, started right up, ran the quad down the road, (this was last year), put it in the barn, shut it off. then a couple weeks later, went to go start it again, and nothing. I have power to the dash lights, horn, turn signals, wench etc, but nothing to the starter switch, and I hate electrical crap. Battery still reads 12.x volts. Any suggestions would be amazing. I've owned it over 2 years, and haven't run 1 tank of gas through it. No time to screw with it, and very frustrated. Hoping someone can offer some advice of value.

son got an old qlink sxs, at first wasnt starting good and was leaking fuel very bad out carb and pooling under it. had a hose off that seemed to go from tank to highest nipple on carb..... put hose back on, cleaned carb, and plug. now doesnt leak and cranks fine, but once engine warms wants to cut out back fire and die.....will crank right back up and idle fine until give throttle ....i mean looks like a carb to me ........has fuel pump though.....i dunno if those two will even work correctly together, does this sound right? or did someone just try to force this to work? please help!!!!!

Hi, Just purchased a 2010 Qlink Frontrunner 700. Using it to plow my yard (just moved back to NH). I knew it had starting issues but that was mostly around the starter relay (as shown, when I was looking at it). I rewired (and soldered) the 4 wires that go to relay, replaced the relay, starter and battery. It still starts extremely hard but runs great. I don't know what else to check. On another topic, which way do wheel hub nuts turn to loosen? TIA.