-
Similar Topics
-
By rdc
Hope I posted this in the right place. Looking for the left side shaft carrier where the rear bearings go for an 1100cc sand viper, I understand an 800 cc carrier will also work. I need the old style two bearing with the spacer in the middle, the new style with just the one wide bearing wont work. If anybody has one I'll buy it right away. my email is [email protected]
-
By Sidewinder
All mid 2008 through 2014 Polaris RZR 800 series have a big problem with the rear differential pinion nut backing off, allowing the pinion gear to shoot into the rear differential, destroying the rear differential. This has happened with machines with as little as less than 100 miles on them! Reports indicate that there are no problems, nor warnings, until the rear differential grenades, locking the rear axles solid! This requires the machine to be lifted onto a trailer, to be transported for rear differential replacement, as it destroys the case. After failure, rear differential replacement can be quite expensive: labor alone can run from $800-$1200 and a new OEM Spicer rear diff, if you can find one, can run from $1700-$2500! So, if you own any Polaris RZR 800 series between the years of 2008-2014, I recommend that you do this repair before further use of your machine. personally, I have grounded my machine until it can be done. Please check the online post for your own awareness.
-
By Benny Glasow
We have pretty much decided to buy a Polaris utv to use around the place and for some irrigation stuff. We were thinking about getting a windshield, top, and rear window. All the Polaris utv accessories are pretty pricey and I was wondering if anyone had used some after market accessories? Any other thoughts on stuff that we should put on it?
Thanks
-
By Jamesjoh
I just bought my first Polaris yesterday and I’m waiting for it to be delivered. I opted against getting the windshield and roof from the dealer — he roughly quoted about $1k for both, which seemed a bit steep — so I’m looking around online first.
I’m specifically shopping for Polaris Ranger XP 1000 accessories like windshield, roof, and other gear. Where do you all usually buy from, and do members here get any discounts or preferred vendors?
Thanks!
-
By GTech
I have a 2007 Joyner Commando 650, and cannot find a shift cable. Commando is a 4 speed, and the cable I need is the one to the right side of the shifter if you are sitting in the front seat. Cable is approximately 40", and has an eye on each end. I tried fitting a can-am shift cable, and the ends are just too long to mount and make work. Looking for a supplier so I can get the Joyner moving again with the correct shift cable.
Thank you,
Gary
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.