Ok here is what I have I think it is a Hisun, or at least that is what others have told me. I have no spark at the plug so I have replaced the coil, the wire, the plug, the regulator, and I have the crank shaft position sensor (have a question about that thing.) So on one side I of the coil the white black I have solid 12, but on the other side I have 0. Chased the wire back to the solenoid and when plugged in have 12 until you turn key to start then it drops to 0, so wondering if there is a break in the blue black from the solenoid to the coil, will run a test on that later this week. But I have ordered a new solenoid because I do not think it should drop to 0 when the key is turned either should push it 12 on both side if it works like most. So the question is what is going on and what am I missing here? Any ideas? The next question is where does the crank shaft position sensor go? None of the books I have show where it goes and I have hunted all over that engine and can not find the silly thing. So please help?
