David Owens

Ok have looked at that and that part was replaced when I replaced the stator.  However, same problem no spark.

Ok update on this, beyond the changing the coil.  I did tear it down and change the stator but have yet to find the crank shaft position sensor or anything that looks like it.  So someone please tell me where that silly thing isIMG_5582.HEICIMG_5583.HEICIMG_5584.HEICIMG_5585.HEIC

IMG_5530.HEICIMG_5531.HEICHere are the only two things I could find that say anything about a make a model, where you would think the all the important information is looks like it was a sticker and has been worn off and was not stamped in metal.  Ok where can I find a service manual that shows where it is?  I have a replacement already.

Ok here is what I have I think it is a Hisun, or at least that is what others have told me.  I have no spark at the plug so I have replaced the coil, the wire, the plug, the regulator, and I have the crank shaft position sensor (have a question about that thing.)  So on one side I of the coil the white black I have solid 12, but on the other side I have 0.  Chased the wire back to the solenoid and when plugged in have 12 until you turn key to start then it drops to 0, so wondering if there is a break in the blue black from the solenoid to the coil, will run a test on that later this week.  But I have ordered a new solenoid because I do not think it should drop to 0 when the key is turned either should push it 12 on both side if it works like most.  So the question is what is going on and what am I missing here?  Any ideas?  The next question is where does the crank shaft position sensor go?  None of the books I have show where it goes and I have hunted all over that engine and can not find the silly thing.  So please help?