2013 Polaris RZR XP 4 900
-
Similar Topics
-
By Sidewinder
All mid 2008 through 2014 Polaris RZR 800 series have a big problem with the rear differential pinion nut backing off, allowing the pinion gear to shoot into the rear differential, destroying the rear differential. This has happened with machines with as little as less than 100 miles on them! Reports indicate that there are no problems, nor warnings, until the rear differential grenades, locking the rear axles solid! This requires the machine to be lifted onto a trailer, to be transported for rear differential replacement, as it destroys the case. After failure, rear differential replacement can be quite expensive: labor alone can run from $800-$1200 and a new OEM Spicer rear diff, if you can find one, can run from $1700-$2500! So, if you own any Polaris RZR 800 series between the years of 2008-2014, I recommend that you do this repair before further use of your machine. personally, I have grounded my machine until it can be done. Please check the online post for your own awareness.
-
By Benny Glasow
We have pretty much decided to buy a Polaris utv to use around the place and for some irrigation stuff. We were thinking about getting a windshield, top, and rear window. All the Polaris utv accessories are pretty pricey and I was wondering if anyone had used some after market accessories? Any other thoughts on stuff that we should put on it?
Thanks
-
By Jamesjoh
I just bought my first Polaris yesterday and I’m waiting for it to be delivered. I opted against getting the windshield and roof from the dealer — he roughly quoted about $1k for both, which seemed a bit steep — so I’m looking around online first.
I’m specifically shopping for Polaris Ranger XP 1000 accessories like windshield, roof, and other gear. Where do you all usually buy from, and do members here get any discounts or preferred vendors?
Thanks!
-
By Green_Manalishi
2013 KAF650 Mule
Howdy! I'm repairing a Mule for my father-in-law and can't find the correct wiring diagram. The 4 wires for the sending unit and fuel pump are attached at the pump, however the other end has been pulled out of wherever they go.
I looked at the fuel pump relay and both fuse boxes, but I can't figure out where the 4 wires need to go. They seem to be long enough to get there. They may have been yanked out of the main harness, not sure how though...
If anyone has the same or similar model, just trace the wires from the top of the tank and let me know where they go!
-
By Bobcat 3600xl
Hey I need front axles for 2013 bobcat 3600 xl crew gas. Polaris builds these for bobcat. I’ve tried the Polaris 500 and axles were to short. Nobody shows measurements. Any idea. Oem # 7027507. Do I try the 800 Polaris axles. Any help appreciated
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.