Quantcast
Jump to content

Team Industries SmartPlow


utvman

Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By MOTORHEAD1959
      ATV just clicks when trying to start. Battery is good, has a new starter, and all the wiring looks good. any suggestions on where to go from here? thanks 
    • By alevins
      Good day all, 
      searching here but cannot find the answer,  Hisun been working fine and now reverse limiter seems to be engaging and cannot back up, cannot find a clear solution to disable the limiter. found a possible relay?  not sure which one or to cuut a wire at ecu but a picture or diagram would be helpful
      thank you for any help in advance
    • By Charles Hines
      I have a 2022 Coleman 400 utv. I have added a heater with a 3 speed fan. I notice that while running with nothing on, the battery voltage gets to about 13,7 volts when funning at speed. If I turn on the lights, the voltage drops to about 12.3,if I turn on the heater fan with the lights on, the battery light will come on. I have replaced the battery with a higher capacity one and have replaced the regulator/rectifier, both have made no difference. I have measured the ac voltage at 22 vac at idle across all 3 phases, so the stator is charging. I have never had any issues with not starting or running poorly due to low voltage. Just wondering if there is anything I can do to increase the voltage from the regulator or is this just a underachieving system?
       
    • By johnpeter
      2021 Polaris Recreation/Utility RANGER CREW XP 1000 On Ebay
      https://www.ebay.com/itm/276332773280?

    • By Dave P
      Bought a used 4x4, engine runs. Tried rebuilding both pulleys. Ended up buying a transmission pulley system. The new one is aftermarket. The old one wallowed out and fell off.
      The new one seems not to have enough splines inside. Seems like it is freewheeling. When it revs up and gets smaller pulley diameter, does it jump on the spline shaft? The driver pulley on the engine gets larger when it revs up. Had to make a pvc collar for the belt to sit on in the grove. No parts for sale on this pulley. Is the belt supposed to sit at the bottom? There must be a trick to get the belt on. Any ideas?
       
      Thanks Dave in Florida
       
       
×
×
  • Create New...