-
Similar Topics
-
By dmadline
500s SxS won't start. Battery is good.
The relays are clicking but will not turn over. It is cold here -10° Fahrenheit. Looking for help to figure out what's going on. Thanks,
-
By ShugBear
Coleman 550 2019 UTV wont start.
I have changed the spark plug working fine with test, All gas has been changed plus added Sea Foam, Change fuel injector, fuel pump is pumping and works, Still will not fire, Need Help Please. Thank you
-
By Kevin M
Hello all. I am new to this forum and new to SxS in general. I recently purchased an 16 Odes Dom 800 with the issue of a prominent knocking noise at idle and it’s very jerky in forward and reverse gears. It does not sound like an engine knock. I bought it cheap knowing about this problem with hopes of it being a cheap and fairly easy fix that I can do myself. Would a bad belt be the cause this symptom? I’m looking for a starting point to begin diagnosing and fixing the problem. I recorded a video of it but am not sure if I can post it on the forum. Any help is greatly appreciated.
-
By BeachBuggy
Massimo Buck 250 less than a year old. 900 miles on it. Live on beach in TX...i.e. corrosive salt air and normally mild temps.
The story - one day, it randomly quit on idle and was tough to restart. Next day, it occasionally cut out for 1-2 seconds while driving, then catch back to normal throttle. Pumped gas pedal, not sure if that helped it catch. Added some marine sta-bil and filled tank. Ran well after that for a day. Following day, wouldn't start. Turns over, cranks, but won't start. When it quit on idle that was the first time driven since we did have a freeze of ~25 degrees.
Full charge on battery. No spark. Changed plug and still no spark. Fuses look good, but fuse connection box has some loose clasps and spade were corroded. I bent clasps best I could and used dielectric on spades re-inserted. Cleaned and checked every connection I could find. Don't have a card reader to hook up, but did swapped ECU just to check that, and no change...after swapping ECU the engine light now stays on. Previously blinked and then goes away.
Under warranty but service place is 2 hrs away.
thanks!
-
By Jon Spruill
Hey Guys, I have been chasing a stalling condition for about two weeks now. The bike will crank up and idle fine, then after about 20 seconds it will fall on its face and stall. It happens at both idle and while running at various rpms. You can turn the key off, turn it back on and it will fire right back up without trouble. I have verified spark on both cylinders with a spark tester. I have also added an inline fuel filter, and pulled the injectors to verify proper pulse on each. Things I have replaced - (relearn procedure performed after each component replaced): spark plugs, ECU, relay/fuse box, fuel pump, & throttle position sensor - all with no improvement of the condition. The only warning light I get when the condition occurs is the oil lamp. The bike only has 14 miles. I am at a loss and appreciate any help and suggestions! Thanks
-
-
-
Similar Tagged Content
-
Gallery Images
.jpg.84decc2b5f73a0d00e4b249aedfba113.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.