Quantcast
Jump to content


Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By MilSurpYinzer
      I heard there's several off road festivals out that way. One or two post apocalyptic, the rest just rev and run. Anyone know a good one that offers camping? Any advice for out of state people like hauling, legality, and where to stay?
      Ideally me and the missus would be down for camping out and setting up shop somewhere nearby. That way we can just wake up, load up, and ride.
    • By Edelbrock
      Nice Offroad rig. 





    • By Alien10
      I have a Coleman Outfitter 550 purchased in January 2022 that runs and operates pretty well.  65 hours on it so far.   It is a work vehicle for my 10 hilly acres with two 1 acre woods and 5 acres of "lawn".  The rest is under a lake. 
      My parking brake does not seem to have any grip.  It worked when new but after a month or so, it is just almost useless.     I press the parking brake pedal hard until it stops. Still, it won't hold even on slight inclines.   I don't see the caliper move as I press the brake pedal down.  There seems to be plenty of pad left on it and the rotor is shiny as if it is rubbing a little when applied, but not enough to stop it from rolling. 
      Any thoughts on possible causes? 
       
    • By hdtran
      Hy (pronounce he), just bought a Hisun Sector E1.
      I'll be using it to haul logs and stuff in the Sangre de Cristo mountains.
    • By J R
      Hi, I just bought a used 2015 MSU500  with 365 hrs on it. After riding it the UTV seemed sluggish and would not climb a moderate hill without getting a running start in low range. Took it to a repair shop and they told me that the clutches were burnt and slipping. Had the primary clutch replaced and afterwards was told that the compression of the cylinder was only 80psi, which I was told was 100psi below original compression. I've bought all parts necessary, including new crankshaft and bearings to rebuild the motor. My question is, does anyone know if a 700cc top end kit will bolt onto the 500 motor case?
×
×
  • Create New...