Quantcast
Jump to content

2017 Massimo MSU-500 Cranks but won't start.


Tim Nelson

Recommended Posts

Ok guys, my turn...

Working on my neighbors 2017 Massimo MSU-500.  Initial complaint was it would start and run for about 10 minutes and the just die.  He replaced the fuel pump and still had the same issue.  I stopped over one day to look at it and saw that it had codes flashing on the dash; 505, 336 and 337.  We decided to get a new stator/crank sensor.  Took it apart installed the new stator/crank sensor and nothing.  It won't even start.  I checked the pins on the crank sensor plug and one was in the wrong place, so I repinned it and it still won't start.  I double checked the connectors and all is good.  I checked the wires from the ECU to the coil, good.  It appears to have spark every once and awhile but not enough to start.  I replaced the coil with a known good one and still nothing.  I bought the cables and downloaded the ECU hardware and everything looks good.  I pulled the timing cover back off to check the flywheel keyway, it is good.  I checked the timing and timing chain, good.  I checked the valve lash, good.  I have to put it back together but just wanted to post in case there is something else I should check before hand.  I checked the 9 pin connector and it is clean.  I have battery voltage on the purple wire and pins 15 and 18 on the ECU.  I pulled the air filter off and I am going to put a new plug in it just for the heck of it.  What ECU inputs would prevent it from starting?  Why would it now not start at all after replacing the stator/crank sensor? It has to be something simple.  Any help would be appreciated.

Link to comment
Share on other sites

  • 3 weeks later...

the computer back up to it, I noticed I was not getting a RPM reading and was getting a CKP sensor error which meant it was not getting the correct counts. I took the flywheel cover back off to check the air gap. Not much movement but moved it as close to the inside as possible. I then compared the eBay special to the original and noticed that the wire colors were opposite of each other.  I put all back together and it still wouldn’t start. Just for the heck of it I switched the pins on the harness coming from the sensor and BOOM! She fired right up!  I would have never thought that the polarity of the sensor made a difference but it does. Just something to think about when you buy aftermarket parts

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By doncaron
      Hello 
      I have a 2022 Massimo t-boss 550. I’m looking for a fix for my timing problem. It keeps getting out of timing. Now I’m trying to find the proper parts for the linhai motor. I’m looking for tensioner chain and gear. If there’s anything else I can do to fix this issue please let me know. Unfortunately I can’t afford to get something better so I got to get it fixed. Thanks in advance. 
      Don
    • By MOTORHEAD1959
      ATV just clicks when trying to start. Battery is good, has a new starter, and all the wiring looks good. any suggestions on where to go from here? thanks 
    • By Steve B
      My "R" light on the dash will not go out when I take the UTV out of reverse and put it into any other gear. Is this just the light switch issue or will this effect engine performance in the other gears?
    • By Smittay
      (posted a similar question to the Hisun folks) Looked at a lot of UTVs lately. Couple Questions about Massimo. Some people say they are just cheap with no customer service. Other people seem to have no problems with them.
      Any opinions on Massimo durability?
      Heard parts might hard to get. Is that true?
      What models are the best?
      If you had one and didn't like it what do you recommend? 
    • By malenurse13
      We just bought a used 2017 American Landmaster TW450. No hour meter that I can find, so not sure exactly how much it has been used. 
      The first 2 days we had it, the starter was a little sketchy, but it started after 2-3 tries. Sometimes when turning the key, we would hear a loud metal "clink" sound. Like the starter made contact, but didn't have enough power to turn. 
      THIS MORNING... Turning the key, we hear a single click sound. That's it. Even with a new battery, the starter is still doing the same thing. Both batteries (old and new) were reading 12.8 volts on volt meter. So I'm wondering what else could be going on? Any ideas on what to look for would be greatly appreciated...
      Thank you!
×
×
  • Create New...