
Switching the drive trine from a 09 joyner trooper r4 to r2 sand viper
By
Monty Herbold, in New Members Area
-
Similar Topics
-
By M C
Hey guys just bought a 07 trooper. Previous owner stated it ran great etc prior to clutch job then had issues. I drained tank, replaced plugs etc. found one of the injectors connectors was not connected and plugged it in. Solid 50psi fuel pressure. It starts easier than previously on 3 cylinders but still runs very very poorly. I’m thinking the sound I’m hearing is it detonating at around 3k. It kinda sputters and falls apart. Sounds like clicking or something when it happens. I am at a bit of a loss, compression is a solid 150psi across the board with no movement. Verified spark and now am assuming all injector are functioning more or less correct as if I unplug any one it sound terrible at idle.
A note, I tapped plugs at .7 manual called for .9-1.1 but that seems super over doing it but I will try adjusting them to 1.0
additionally I’ve noticed the fan in rear doesn’t turn on.
anyone with any help I will be in your debt.
-
By Travis
View File Kawasaki Mule 550,520,500 Engine repair manual
This file contains all specifications,troubleshooting and repair procedures for the FE290D (9.5H.P,286cc) engine used in the Mule 500,520 and 550 models.
Topics covered include, general information, service data, disassembly, reassembly,inspection of parts and maintenance.
Notes:
Make sure you're reading the correct information as this manual covers multiple FE series engine, some of which were not used in Mules, the manual does a very good job of clarifying which specifications and procedures are for which Model engine.
Submitter Travis Submitted 01/13/2021 Category Kawasaki
-
By Russshaw
Hi, I think I just bought a Husun 450 that is in need of TLC. It is leaking badly from the shifter shaft (located at left foot). I can not find a part number for the seal(s) 3 came off of the shaft.
If anyone can help I would be extremely grateful 🙏
-
By Hillcojim
I’m trying to narrow down a leak. It may be the oil pan.
how difficult to repair this? Is there a gasket or?
thanks!
jim
-
By Anthony Butler
Soo for my second problem lol, 2009 trooper 1100 5 speed , will not engage 5th gear , all others work fine but seems like 5th doesn't engage completely and wont grab the gear. Any idea on where to start looking for issues, or what to look for in regards to linkage.
-