Quantcast
Jump to content

2009 Joyner Trooper that cuts out when it warms up


Recommended Posts

I have a 2009 Trooper that when I first start it it runs great but after about a min it starts to cut out under acceleration but clears out when it gets revved up.  I downloaded the manual from   Joyner-usa.com   but it doesn't help much,  Mine doesn't have a OBD port on it and my son who is a mechanic said he can wire one in if we have a wiring diagram for the CPU but the wiring diagram of the CPU that is in the manual is for a 3 cylinder engine.  The manual talks about a MIL light that can flash out a code but I don't know where that is and even if I did find it they  don't tell me how to read it.  I have tried the coil and the map sensor and that didn't help I checked the TPS and it checks OK.  I emailed Joyner and all I got from them is there should be a OBD port on it and then they said they checked and found some don't have it,  No help from them. Anybody run into this problem or know were I can turn to get some help on this, even a good wiring diagram of the CPU would be a big help.

Thanks for you help

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By malenurse13
      We just bought a used 2017 American Landmaster TW450. No hour meter that I can find, so not sure exactly how much it has been used. 
      The first 2 days we had it, the starter was a little sketchy, but it started after 2-3 tries. Sometimes when turning the key, we would hear a loud metal "clink" sound. Like the starter made contact, but didn't have enough power to turn. 
      THIS MORNING... Turning the key, we hear a single click sound. That's it. Even with a new battery, the starter is still doing the same thing. Both batteries (old and new) were reading 12.8 volts on volt meter. So I'm wondering what else could be going on? Any ideas on what to look for would be greatly appreciated...
      Thank you!
    • By Hugh
      My 2018 Hisun sector crew engine cut off after about 15 minutes run. There is no indicator of what is wrong, no error code just die and won't restart until it cool down. I notice that the fan is not running but the temp indicator is on low temp, no overheat indicator. I checked the radiator fluid, it is cool to touch.
      Cooling fans are working, I can hear it running once awhile if I can get the engine warm up enough.  Thank you for all the help.
       
      Hugh
    • By Paul409
      Have a Hisun 750 only 700hrs 21 model. Never had issues went to start it and there's a clicking sound under the seat I'm assuming it's the started relay. I for the life of me cannot find the starter, is there a way to test the relay. 
      Thank for any support 
    • By DJ Brusenski
      checked all the fuses and relays, I can jump start it with the key in the on position. it will not key start need some help, thanks
    • By LindaCall60
      Purchased a 2011 bighorn banchee. Needs motor work. Not sure what. Husband is mechanic but not computer savvy. So, is there a manual that will tell him how to tear this down?  We have down loaded a service manual, but he says it doesn't tell him what he is looking for. 
×
×
  • Create New...