2009 Polaris Ranger
-
Similar Topics
-
By Sidewinder
All mid 2008 through 2014 Polaris RZR 800 series have a big problem with the rear differential pinion nut backing off, allowing the pinion gear to shoot into the rear differential, destroying the rear differential. This has happened with machines with as little as less than 100 miles on them! Reports indicate that there are no problems, nor warnings, until the rear differential grenades, locking the rear axles solid! This requires the machine to be lifted onto a trailer, to be transported for rear differential replacement, as it destroys the case. After failure, rear differential replacement can be quite expensive: labor alone can run from $800-$1200 and a new OEM Spicer rear diff, if you can find one, can run from $1700-$2500! So, if you own any Polaris RZR 800 series between the years of 2008-2014, I recommend that you do this repair before further use of your machine. personally, I have grounded my machine until it can be done. Please check the online post for your own awareness.
-
By Big Red Dog
Bought my 2009 Yamaha Rhino, (fuel injected of course), recently from the original owner. Only had 500 miles and 70hrs. Starts reliably, however, it will not idle but about 50% of the time. Also, when driving slow in low or high, that is to say, relatively low rpms and below about 10 mph, it bucks and almost wants to die..... not smooth at all. However, at speed (say 12-15 mph or more) it runs very well, like it should. Any ideas?
-
By Benny Glasow
We have pretty much decided to buy a Polaris utv to use around the place and for some irrigation stuff. We were thinking about getting a windshield, top, and rear window. All the Polaris utv accessories are pretty pricey and I was wondering if anyone had used some after market accessories? Any other thoughts on stuff that we should put on it?
Thanks
-
By Jamesjoh
I just bought my first Polaris yesterday and I’m waiting for it to be delivered. I opted against getting the windshield and roof from the dealer — he roughly quoted about $1k for both, which seemed a bit steep — so I’m looking around online first.
I’m specifically shopping for Polaris Ranger XP 1000 accessories like windshield, roof, and other gear. Where do you all usually buy from, and do members here get any discounts or preferred vendors?
Thanks!
-
By EVSupport
We are doing a total rebuild of a 2010EV includes chassis refurbishment with a lot of new steelwork, blasting and powder coating. We have put the main front to back drive shaft in with new UJs, and its showing that the front yoke flicks and clonks and has a lot of movement on the spline. It moves sideways/ flicks is the only way I can describe it. Not something I have seen before. A replacement yoke has been ordered. Any thoughts as to what the cause could have been (other than a previously seized UJ at some point) ?
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.