Quantcast
Jump to content


2008 Cub Cadet Volunteer Tracker won't start

TerryH

By TerryH
in Cub Cadet UTV SxS Forum

 Share

Recommended Posts

TerryH Rookie

TerryH

Posted
Posted

2008 Cub Cadet Volunteer won't start.   It is getting gas, is getting spark, but will not start.  Replaced plugs, and bit the bullet and replaced Engine Control Module (ECU).  Still nothing.  6 months ago replaced short block, starter, new ignition switch (all from Cub Cadet and Kohler).  Any ideas ??????

  • 1 year later...
Cwaterman Newbie

Cwaterman

Posted
Posted
On 1/29/2021 at 6:58 PM, TerryH said:

2008 Cub Cadet Volunteer won't start.   It is getting gas, is getting spark, but will not start.  Replaced plugs, and bit the bullet and replaced Engine Control Module (ECU).  Still nothing.  6 months ago replaced short block, starter, new ignition switch (all from Cub Cadet and Kohler).  Any ideas ??????

Did you ever figure it out? I have a 2008 having same issue, got it to start once but died and wouldn’t fire back up 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Silent3923
      Uv34xl gas transmission
      By Silent3923
      Been waiting over a month and a half for a transmission from bobcat,  they claim the polaris transmission is different.   Can anyone verify that???
    • Hoppy one
      Bennche 500, replaced stator no fire
      By Hoppy one
      I replaced the stator on our Bennche 500 because it was not charging. It ran as long as you kept the battery charged. I replaced the stator now it’s not firing. The only problem I found was a wire in the new stator for the crank position sensor was in the wrong place in the plug. I switched it around but still no fire. Putting a meter on those wires and cranking the motor showed no voltage from the crank position sensor. Something I did or a bad “new “ part? Thanks for any ideas.
    • mfitzner
      No start
      By mfitzner
      Cranks after installing a jumper wire to ignition switch to get power but will not start
      Have spark and fuel pump runs
       
    • Jeff freeman
      Utv wont start and broken fuel injection wire
      By Jeff freeman
      I have a Coleman 550.  Was having problems to start with where it would start and then shut off after a couple tries. It would take off and be good. It then got to a point where it would not start at all. I replaced the fuel injection twice the second time I replaced it I noticed a mouse or something had chewed one of the wires that connect the electrical to the fuel injector. . So two-part question first does anybody have a part number for that wire harness?  Second, any other ideas after I fix the wire harness permanently on what could keep it from starting I have gas flow up to the fuel injector.


    • JohnnyB
      Massimo 500 will not start
      By JohnnyB
      My Massimo 500 will not start. I’ve checked all the obvious things. It turns over just fine. fuel, spark, fuse box are all good. I can’t figure it out. Any ideas would be greatly appreciated. Thank you.

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...