Quantcast
Jump to content

Bogging in reverse

MarioBram

By MarioBram
in Hisun UTV SxS Forum

 Share

Recommended Posts

  • 2 weeks later...
MarioBram Newbie

MarioBram

Posted
  • Author
Posted
On 4/23/2022 at 12:14 PM, MarioBram said:

Vector 500 (hisun 500) stared over night takes reverse but bogging down . Forward  Hi & Lo working fine. oil change very recent castrol  Power1  synthetic 10-40 .

any one have an answer for this problem

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • great8redsfan
      2017 Challenger 500 No power on take off or hills
      By great8redsfan
      Okay folks. I have a low power issue. Been like this for a few years. Place I work at bought 3 and all have lost most of the pulling power.  They gave them away after local shop worked on one for 3 months and it had great power for about 1 month and then crap. They replaced throttle body, fuel injector, spark plug and IAC motor. Seat belt switches have wires cut and left open so no seat belt warning light anymore. It revs to 6k rpm in neutral but when put in gear and take off in low it just doesn’t seem to want to go anymore. Running 93 octane fuel with Stabil.  Any ideas greatly appreciated. I dont have a scan tool but no codes on dash. If held to floor it pops a little and runs almost 5K rpm but if I let off pedal about an inch it smoothed out and revs up to 6k rpm. 
    • JimS409
      2011 Hisun 700
      By JimS409
      I picked up this Hisun 700cc for a good deal. no crank no start unit 1900 miles on it. Put a new battery and starter solenoid fired right up but sounded rough some kind of rattle/clunk noise.  Does anyone know what this noise could be? Couldn't get a better video of it running as i don't want to risk doing more damage. Drained the oil it looks good no metal in it. 

      445374820_7315077208620291_6073155782020130975_n.mp4  
    • todd93
      Hisun Sector 550C total electrical failure.
      By todd93
      Hi, all! I. I'm new to the board, hoping someone could help me out! I have a 2020 Hisun Sector 550C that I bought new in 2021. Today, I took some stuff next door to my parents. When I went to leave, I turned on the key, heard the solenoid click, but no lights, no guage activity, no fuel pump, and no starter. 
       
      The battery is good, I checked all the fuses, they are good. Not sure if the relays are good, or even what to look for there. Is it possible that it's maybe a wire? 
      I'm really stumped on this one! Any help would be deeply appreciated! Attached is a pic of the fuse box layout. 
       
      Thanks! 
      Todd 
    • DLJ
      Hisun 800 shuts down
      By DLJ
      Have a Hisun 800 it runs for about 35 minutes then stalls. Crank's over but has no spark. Let it sit for 15 to 20 minutes and it starts and runs again for about 35 minutes. Changed the CDI / ECU controller and still does it.
    • hdtran
      How to wire winch remote on Hisun Sector E1 ?
      By hdtran
      It's not immediately obvious to me how to wire a remote control (wired or wireless) on the Sector E1.
      Has anyone here done this? Do you have pictures on how to get to the wiring?
      Thanks!

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...