I'm having a similar issue with my Axis 500. It seems to bog down and struggle, particularly on inclines/hills (see video). Frustratingly, it also only happens intermittently, more often when the machine has been running for a while (I use it for farm work only). So far I have:
Replaced fuel filter
Replaced fuel injector
Replaced MAP sensor (reset ECU after)
Replaced spark plug
Verified air filter is clean
Verified no obstructions in exhaust
I only run it on 91+ gas and put a can of seafoam through it to no avail
I did previously have an issue with a failed one-way bearing, but this particular issue predates that failure. I replaced the one-way bearing a few months ago and inspected the wet clutch, primary/secondary clutches and belt while I was in there-didn't see anything of concern. Where do I go from here?
IMG_9433.MOV
Got it running. The 4wd gets 12v power but does not engage. The posi traction (rear end) does not engage also. Any one have experience / ideas on fixing these items?
Thanks Dave
Thanks for the info. I did locate the part on partstree and it was very expensive $291.00 plus tax and shipping total $325. The part wasn't much bigger than a quarter. I'll try and include a Pic. Anyway I installed it and the UTV runs well. Yes it is gas not propane. I switched to non-ethonal gas.
Clyde, are you aware that number is for a propane carb. Are you trying to run it on gas? That carb is available for around 300.-00. If you were noty aware that it was propane powered, I would be trying to get a refundGood luckYou may be able to switch it to gas but thats not my forte. Oh, I saw the part available on partstree and a coupla other sites (ebay)