Al-WI
Members-
Posts
4 -
Joined
-
Last visited
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Al-WI's Achievements
-
2006 4x4 volunteer runs slow, barely goes uphill.
Al-WI replied to Saint's topic in Cub Cadet UTV SxS Forum
I meant “If it has gas engine” -
2006 4x4 volunteer runs slow, barely goes uphill.
Al-WI replied to Saint's topic in Cub Cadet UTV SxS Forum
If it has engine I had a similar problem a while back. Pulled okay on level but no power up hill and smoked under power. One of the plugs was badly fouled. Replaced plugs and it ran better but still ‘stumbled’ a lot. Found the plugs fouling again from too rich a mixture. I removed the air cleaner cover and found a mouse nest around the air filter. Cleaned it out, replaced the air filter and it’s running fine again. My suggestion, try new plugs and air filter. -
Al-WI started following 2005 Cub Cadet side by side front axles and 2006 4x4 volunteer runs slow, barely goes uphill.
-
2006 4x4 volunteer runs slow, barely goes uphill.
Al-WI replied to Saint's topic in Cub Cadet UTV SxS Forum
Diesel or gas engine? -
2005 Cub Cadet side by side front axles
Al-WI replied to Robbie Wyre's topic in Cub Cadet UTV SxS Forum
I realize this is a rather old thread but I had similar problem and found a simple solution. The axle spline was seized in the differential and no prying, pulling, cussing got it to move. I found that my cheap Harbor Freight bearing separator just fit between the CV joint and the differential. Started tightening it up with the impact wrench and the spline popped right out. Cleaned out the really rusty differential spline ‘socket’ and loaded the new axle spline with anti-seize and everything slid back together smoothly. https://www.harborfreight.com/bearing-separator-and-puller-set-62593.html