Quantcast
Jump to content


Recommended Posts

Posted

It's also possible you have an air pocket in the coolant causing the switch not to heat up enough. Did you burp to confirm? These things are prone to air pockets when filling and ive read a number of people having air in the shstem from the factory.

There's a small burping port on where the coolant goes into the engine.

Posted

a leaking head gasket will put air into coolant as well.  Hisun engines are known for head gasket failure.... while its running hot, look at coolant recovery bottle.. if you see tiny bumbles rising, its a head gasket leak.. hopefully its just your sender. you can jump it to run continuously til you can replace it

Posted

Thanks Joe. I ordered a toggle switch so I can turn it on and off. Will check to see if I have bubbles. Engine was under hi load I was pulling a gravel driveway grader.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By CSM_Retired
      Has anyone installed the power dump on a Kioti K9? If so, does it eliminate the safety lock? Does it work well?
      Thanks for your input
    • By amiracle40995
      I’m getting a 700-7 every startup. I’m having to change the plug every 100 miles on 93 octane gas. I got a lower numbered plug that is supposed to burn hotter. I’m wondering why that comes up every time I start it and if it’s related? I included a picture of the code or whatever it is. I haven’t seen the code in the owners manual or the hisun shop manual I have. 

    • By Homeowner A
      What's the best replacement battery option for a Coleman UTV 400?  
    • By SkyPilot56
      working on a coleman 550 out fitter , had a shit load of codes, coil, injector , and the map sensor for fuel injector replaced all 3 and figured it would start , but no joy have spark (new plug also and inline fuel filter) cleared the codes and still have the engine light , turns over fine but damn thing still will not start, friends daughters were driving it and turned it off to park , and went back to start it and same thing turns over but will not start , with this machine anyone have any ideas as to what the hell , I should be looking for , no plug's unplug checked wires none seem to be pulled apart or broken !
    • By Some random dude
      2015 Hisun 700 Utv
      the break pedal seems to not fully throw therefore it won’t engage the switch in order to start. 
      it throws enough to stop the UTV but not enough to engage the switch. 
      I used it this morning, started fine, did some work then shut it off to talk to a neighbour and it wouldn’t start after. I can hear the injectors working but the break pedal doesn’t seem to go all the way down. 
×
×
  • Create New...