Quantcast
Jump to content

Coleman UTV500-4 EFI service manual needed

Paul Ramey

By Paul Ramey
in Coleman UTV SxS Forum

 Share

Recommended Posts

aefron88 Community Regular

aefron88

Posted
Posted

I assume you looked thru all the 500 manuals  in the download section and theyre all for the carbed version?

It should be substantially similar to the 550 model, all the EFI, and mechanical is essentially the same AFAIK just a slightly different size piston, infact all the Hisun models are very mechanically simila, with differences in bodies, accessories, and minor driveline changes due to spacing requirements.

Do you have anything in particular you need help with?

Link to comment
Share on other sites
Paul Ramey Newbie

Paul Ramey

Posted
  • Author
Posted

I see that the 500 and 550 are almost the same. The 550 can give error codes from the dashboard, I don't think the 500 can, not the same dashboard. . Trying to find out why the motor is losing power/fuel and need info on parking brake replacement.

All the info in the 500 files are for carb motors.   I am thinking that not many 500's were made before they switched to the 550.

I like to do my own work, but hard to do it without good tech info

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Mark T
      Can I put a larger engine in my 400 colman UTV ?
      By Mark T
      MY 400 is gutless. I would like to know if I can upgrade to a larger engine ?
    • great8redsfan
      2017 Challenger 500 No power on take off or hills
      By great8redsfan
      Okay folks. I have a low power issue. Been like this for a few years. Place I work at bought 3 and all have lost most of the pulling power.  They gave them away after local shop worked on one for 3 months and it had great power for about 1 month and then crap. They replaced throttle body, fuel injector, spark plug and IAC motor. Seat belt switches have wires cut and left open so no seat belt warning light anymore. It revs to 6k rpm in neutral but when put in gear and take off in low it just doesn’t seem to want to go anymore. Running 93 octane fuel with Stabil.  Any ideas greatly appreciated. I dont have a scan tool but no codes on dash. If held to floor it pops a little and runs almost 5K rpm but if I let off pedal about an inch it smoothed out and revs up to 6k rpm. 
    • donwan
      2017 Hisun Strike 900 Service Manual
      By donwan
      View File 2017 Hisun Strike 900 Service Manual
      Here's the service manual for the 2017 hisun strike 900.
      Submitter donwan Submitted 05/29/2024 Category Hisun  
    • Buddee
      2010 500 - New Carb- Hesitation
      By Buddee
      Put a new carb on the 500 to replace the leaking OE one.  Machine idles fine and mid and top end runs great.  It tends to have a hesitation right from the start - bottom end.   Thinking it may be the air/fuel screw??  I didn't do anything with the carb out of the box and is it direct replacement for my machine.  Of interest is the manual choke doesn't seem to work very good now.... wonder is it getting too much air?
       
      Any help appreciated!
       
       
    • tim hughes
      2021 axis 500 belt issues
      By tim hughes
      does any one else have a slipping belt on the hisun ...i put new wet clutch one way bearing new belt, cleaned primary and secondary and still get slight slippage

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...