Quantcast
Jump to content


Recommended Posts

Posted

Hey all. I need to change my plug in my ut400 and I remember seeing people in here saying to get a certain one that was better than what it came with. What was it?

Also I need to do an oil change. Are the tractor supply oil change kits ok to use?

 

Any help here is appreciated!

Posted

You might have better luck in the "coleman" forum.

Yes the TSC oil change kit should be ok. Make sure the oil is ok for a wet clutch, there are UTV/ATV/Motorcycle specific oils or Shell Rotella that are wet clutch compatable.

As far as plugs look up the iridium cross reference. Some people have gone up a heat range to reduce fouling, but you run the risk of knocking.

Posted

Just Dont use a full synthetic auto oil,, will destroy your wet clutch .. I use Castrol Actevo  in all of mine.  Buying expensive plug is waste.. You wont drive 100,000  miles and thats the only advantage to exotics. Copper plugs have better spark... 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By rdc
      I posted this before , but I had the year wrong. The part I need is for a 2014, I don't know what all years will work, but I need the 2 bearing style with the spacer in the middle. It looks like this pic. If anyone has one I'll buy it rite away. my email is [email protected]. Thanks, RC

    • By Dave Jones
      So with seat belt on  I can only get up to 20mph then it starts bucking until I get under 20 again. Diconnected the seatbelt and same thing. Reconnected seatbelt and unplugged speed sensor. Zoom..it flies. But now I have no speedometer. I have a new speedometer sensor on the way..any other ideas?
    • By mrpro
      My 2022 Coleman/Hisun UTV 400 steering shaft has a couple of U-joints and angles to help get it down from the steering column to the rack.  Today, my son who drives it most came in and said that it wouldn't steer and that he could turn the steering wheel but it doesn't turn the wheels  I investigated and noticed that the bolt that clamps down the upper part of the steering shaft onto the lower one before the first u-joint in the steering shaft had fallen out.  We haven't been able to find it, so I wanted to see what size and thread, bolt I should get to fix it?  
    • By Pajer
      Does anyone know where the winch fuse is located on a 2021 ut400? I’ve been working on the solenoid because the winch will only go in one direction..
      Either in or out depending if I reverse the leads on the solenoid. Now I have no power to the solenoid and it appears I blew a fuse. Winch is supposed to have a 30 amp fuse.
       
      i checked all the fuses in the fuse box near the battery and the 30amp fuse hanging in the compartment. Everything is good there.
      but I can’t locate any other fuses. Any help would be appreciated.
    • By jon pino
      having trouble with a 2013 uxv500i. have replaced stator due to bad pulser coil. new unit does not work. manual value for pulser coil is 100ish ohm, measured value is 500 ohm. can anyone with one of these fuel injected later model units check their pulser coil with an ohm meter for me? left side of engine small connector next to 3 yellows. jon 605-545-7040
×
×
  • Create New...