Hey guys. I have a 2020 rebel west rlx1500. Does anyone make or offer different ratio front and rear diff gears? I’ve searched the web but not a lot of info about it. I’m wanting to lower the gear ratio and run taller tires. Thanks in advance.
By Jon Spruill
Hey Guys, I have been chasing a stalling condition for about two weeks now. The bike will crank up and idle fine, then after about 20 seconds it will fall on its face and stall. It happens at both idle and while running at various rpms. You can turn the key off, turn it back on and it will fire right back up without trouble. I have verified spark on both cylinders with a spark tester. I have also added an inline fuel filter, and pulled the injectors to verify proper pulse on each. Things I have replaced - (relearn procedure performed after each component replaced): spark plugs, ECU, relay/fuse box, fuel pump, & throttle position sensor - all with no improvement of the condition. The only warning light I get when the condition occurs is the oil lamp. The bike only has 14 miles. I am at a loss and appreciate any help and suggestions! Thanks
I'll post pictures next week on my rebuild, which I have completed successfully...👍
It says someplace limited slip rear dif. On my hoist both tires turn at the same time, same direction. The problem I have is that on hard pack, they stay locked up and I'm digging up my driveway on sharp turns. I'm sure in the summer on turf, I'll have holes in my yard. It acts like a solid live axle on a small ATV.
There's a wire running to the rear diff that I thought was the lock up for the rear end. But it's locked all the time.
Question, how is it supposed to work? Is it supposed to slip under hard turns etc?
I'll have to do something to disengage it for the summer, options, thoughts?
Thanks in advance, Dan
I have a 2021 Coleman 400 from TSC. Got it slightly used with 20 hours on it.
Started from scratch with oil change
Iridium Spark plug
Is there a diagram anywhere that shows where all of the grease fittings are at to make sure that I don’t miss any?
On the rear brake it seems to be engaged slightly when moving. The parking brake is not set and released, do I need to start looking at the caliper to see if it can be adjusted to open it slightly or is that an E brake adjustment? Not sure and wanted to get opinions before I start jumping into things I don’t need to! It’s just engaged enough to make a slight squeak.
Any suggestions are most welcome.