Quantcast
Jump to content


Mule 3010 fuel pump relay

newt

By newt
in Kawasaki UTV SxS Forum

 Share

Recommended Posts

newt Newbie

newt

Posted
Posted

I have a Mule 3010 and love it

but i don't have any power to the fuel pump and if someone know were the relay is or has a diagram

i would like to hear from you

  • 9 months later...
mrOkie Apprentice

mrOkie

Posted
Posted

There is a complete circuit diagram of the fuel pump relay, fuel pump circuits in the Service manual electrical section on page 17-39. There are three wires connecting the relay, one is from the ignition switch, the other is from the ignitor and the third wire goes to the fuel pump. My interpertion is that the ignitor signal permits current flow from the 12 volt input from the ignition switch to the fuel pump positive lead, so that means the engine ignitor must be fireing (engine running) in order that the fuel pump runs. The Fuel Pump Relay is not a common solenoid type relay. The original fuel pump also appears to have a pressure sensitive cutoff switch built into the fuel pump, that relieves the pressure on the float needle valve, when the float bowl is full.

I could be wrong but that is my observation from the service manual information.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Popular Now

  • Similar Topics

    • Garjess
      RTV 1140 Starter Relay
      By Garjess
      My rtv 1140 won't turn over.  I've jumped the neutral switch, and the brake switch, and checked the ignition switch. I'm not getting any power to the trigger wire on the starter solenoid.  It starts fine with the key on and putting power to the trigger wire on the solonoid.
      Does a 2010 RTV 1140 cpx have a starter relay? 
      Does anyone have a wiring diagram?
    • Kierobi
      MSU 500 Fuel Pump Ground
      By Kierobi
      Have a MSU 500 that we got from my wife's uncle a while back. We've had it running and hauling around the property but it stopped a few months ago after what I thought was running out of gas and I'm just getting to looking into it. 
      Had fuel to the injector but nothing coming out the injector so swapped with new injector and installed inline filter in the supply hose from fuel pump. Tried again and still nothing but noticed this time that I can't hear the fuel pump priming. 
      Pulled off the electrical connection and I'm getting 12V to the fuel pump but it won't run. Put it on a test bench and got it to run so put test lamp between +ve and -ve terminals on the connector and nothing. Checked against the passenger seat securing post and get a light. 
      Tried chasing the wire back and think that the ground is through the ECU but not 100% sure. Can someone confirm for me? And if it is through the ECU, is the ECU just grounded against the frame or is it wired through to the battery?
      Thanks in advance and hope this all make sense!
    • Butch
      2023 Hisun Axis 700 fuel problem
      By Butch
      I have a AXIS 700 EFI Fuel pump pressure stays at 40 psi and when return line is blocked the pressure goes to 60 psi. and wll only run with return line closed. 
    • mike.s.
      Kawasaki mule model 2010, 4x4, gas motor, sell or trade
      By mike.s.
      SOLD 
       
       
       
       
    • Jeff freeman
      Utv wont start and broken fuel injection wire
      By Jeff freeman
      I have a Coleman 550.  Was having problems to start with where it would start and then shut off after a couple tries. It would take off and be good. It then got to a point where it would not start at all. I replaced the fuel injection twice the second time I replaced it I noticed a mouse or something had chewed one of the wires that connect the electrical to the fuel injector. . So two-part question first does anybody have a part number for that wire harness?  Second, any other ideas after I fix the wire harness permanently on what could keep it from starting I have gas flow up to the fuel injector.


UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...