Quantcast
Jump to content


1994? Mule 2500

norseman

By norseman
in Kawasaki UTV SxS Forum

 Share

Recommended Posts

norseman Newbie

norseman

Posted
Posted

Hello

New to the forum.

I rescued what I was told was a 1994 2500 from rusting away next to a barn. Was told the motor runs but has water in the oil. I found some numbers stamped on the cross tube under the dash but all I can make out is KAF620C the longer number above is so faded it is not ledgeable. I have check other area but cannot find anything else.

Engine has a spline shaft. Need to try to verify the year.

Thank you

  • 3 months later...
xcycle Rookie

xcycle

Posted
Posted

The VIN on Mules are usually on a plate mounted to the frame at the front of the vehicle(mine is hard to see but is just to the left of the the plastic radiator cover) or sometime on frame near the middle of the seat.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • mike.s.
      Kawasaki mule model 2010, 4x4, gas motor, sell or trade
      By mike.s.
      SOLD 
       
       
       
       
    • Rmillerdesigns
      Massimo Msu 500 Has No Power
      By Rmillerdesigns
      Hello. I have a 2016 Massimo MSU 500. I was putting on a lightbar and i screwed up and didn't disconnect the battery so when i was taking of the positive cable to put on the power from the lightbar it sparked and now the utv has no power. I turn the key over and all i hear is a chirp. No lights or anything. Everything that comes from the battery to the jumper box up by the battery shows voltage but anything coming out does not such as to the winch or anything like that
    • Outlaw Redneck
      How to make a commando transmission work in sand spider
      By Outlaw Redneck
      Hello all. I have a 2005 Joyner sand spider 650 with the dreaded broken output shaft on the transmission. I got ahold of a 2007 joyner commando 650 for cheap that had a bad motor but a good transmission. I got it because everything i read said that the transmission would work but it seems that it will not. Due to the commando being 4x4 it has a selectable locker and a small ring gear using a "idler" gear to turn the ring gear which make the output spin the wrong direction. Is there any way that I can make this thing work? I really dont want a commando,  I like the buggy but if the trans wont work then I can only put my motor in the commando. Any help would be appreciated. I have the ring gear from the original trans but the shaft is broken and the shaft from the commando wont fit the ring gear it doesn't appear. 
    • riggy400
      2020 Coleman 400 Water Pump EXTRA O-ring??
      By riggy400
      Bought a Coleman 400 UTV (pretty much a Hisun), the previous owner tried to replace the timing chain, couldn't time it properly and sold it to me. After some hours I figured out how the timing all is supposed to be set (I think/hope) and as I am reassembling, I noticed that the water pump gear was awfully hard to spin. I held the gear with my hand and spun off the impeller. I checked the bearing, spins great no obvious issues noticed other than this o-ring which seems to be out of place? When I remove this o-ring and reassemble the WP, it seems to spin nice and easy without a drag. I looked up the service manual (although very inaccurate info there often) and don't see this o-ring present. Am I missing something here or what? Any input? 
      This is not easy to access once the engine is back in the machine so would like to avoid having to deal with this if it becomes a problem.

    • Speedy
      2008 HiSun 700 Atv parting out because the motor is bad. Anybody need parts because I still have the whole rig!
      By Speedy

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...