Parting out Joyner Sand Viper 1100

[180gtr]

Parting out a rolled Sand viper 1100. I will list some of the parts I have, otherwise ask me if there is something specific you are looking for. I am selling everything I have for $800. I am located near Glenwood Springs CO.

SOLD ITEMS, I do not have these items.

Wheels

Tires

Engine

Transmission

Axles

Shocks

Control Arms

Things I have....These all came off of the running engine. I have video of it running if anyone needs to verify that.

Throttle Body $90
Starter $150
Alternator $150
Fuel rail, injectors, fpr $100
fuel pump $70
Map Sensor $50
Full set of Guages $150
Exhaust w cat, O2 SOLD
Ignition Coil - SOLD
Wiring harness and ecu SOLD
Radiator, shroud, elec fan, overflow tank $200

Fuel tank w sender $150 Has dent at base of fuel neck, no leaks

I have a box full of misc bolts, nuts, etc.

I will sell the Chassis or Frame alone for $200. The chassis is in pretty good shape, needs some cage repair and 2 areas straightened where control arms mount. If anyone had an automotive frame machine it would take a few hours.

That would include....

Brake calipers, lines, pedal, master cyl, E brake assy,

Steering shaft, wheel

Ignition switch, key

Light bar frame, 2 lights

misc hardware, spindles

2 hubs, rotors

Engine mounts

Throttle pedal, cables

Shifter, cables

Clutch master, pedal

I am sure I am forgetting something.

I am parting this out of ebay right now, I just picked up another project and could use the room. No I will not take less than $700 for all of it or $200 for the frame. I do not need to sell it, I will make far more parting it out but would like the extra space in the garage.

If interested I also have an 07 1000rr engine setup I would sell with the buggy for $650.

Thanks!

[180gtr]

New lower prices plus a 1000rr engine setup!

[GauntletZ28]

Do you still have the wiring harness and Ecu

[180gtr]

Sorry, sold

[djflizo]

Do you have any parts left? Also, where are you located if you do have parts left, thanks! 

[rdc]

On 11/1/2014 at 8:20 AM, 180gtr said:

Parting out a rolled Sand viper 1100. I will list some of the parts I have, otherwise ask me if there is something specific you are looking for. I am selling everything I have for $800. I am located near Glenwood Springs CO. Do

Do you have a joyner 1100 rear half shaft carrier bearing housing? I think that's what it's called. Can't find one anywhere. Thanks, RC