
In search of Trooper front ring gear and pinnion
By
flyenj68, in Joyner UTV SxS Forum
-
Similar Topics
-
By M C
Hey guys just bought a 07 trooper. Previous owner stated it ran great etc prior to clutch job then had issues. I drained tank, replaced plugs etc. found one of the injectors connectors was not connected and plugged it in. Solid 50psi fuel pressure. It starts easier than previously on 3 cylinders but still runs very very poorly. I’m thinking the sound I’m hearing is it detonating at around 3k. It kinda sputters and falls apart. Sounds like clicking or something when it happens. I am at a bit of a loss, compression is a solid 150psi across the board with no movement. Verified spark and now am assuming all injector are functioning more or less correct as if I unplug any one it sound terrible at idle.
A note, I tapped plugs at .7 manual called for .9-1.1 but that seems super over doing it but I will try adjusting them to 1.0
additionally I’ve noticed the fan in rear doesn’t turn on.
anyone with any help I will be in your debt.
-
By ANIL SEDALI
Hi friends. I'm Anıl. I live in Turkey. I have a Hisun 700 UTV 2015 Models. My problem is :
inability to change gear after the engine has started. Before the engine starts, it can shift into all gears; but after running, I cannot change gear. At about 3000 km. Fuel injection model. Can anyone help on this topic? Thank you!
-
By Travis
Hi, all, I am here to say i have found an excellent source for kawasaki parts, It's run by Eddie Babbit. It is called Kawasaki Partshouse. run by Babbits online, Muskegon Michigan. http://www.kawasakipartshouse.com/oemparts
Just the other day i ordered piston rings, for my Mule 550, They got here and a Oil ring, and smaller ring were missing from the box, Kawasaki took responsibility for the "Accident" and I had also contacted babbits, and they replied and they said" keep the old rings, order a new set and you just pay shipping" so i got $30 piston rings for 8.95!!!? Free shipping on orders over $50!!!
-
By Chris Miller
Good Morning Folks..Happy New Year, I have been having some intermittent issues with my 2015 American Landmaster LM500 not going into neutral. Seems if I shut the engine off it would pop into neutral. Yesterday I was splitting firewood with a 500 pound log splitter that I pushed to my wood area up a slight grade. I was not able to get it into neutral which I assumed was due to the pressure of the weight of the splitter pushing back. after I finished splitting wood, I used the weight of the splitter to roll back down the hill to my driveway. I unhooked the splitter but still could not get it to go into neutral or start. I dragged it back into my barn with my mower as I don't leave anything outside over night. I am at a loss what to check to try to fix this. I use my UTV (Eustas) every day that I am at my place where I keep it and will be lost without it. Thoughts?
-
By Russshaw
Hi, I think I just bought a Husun 450 that is in need of TLC. It is leaking badly from the shifter shaft (located at left foot). I can not find a part number for the seal(s) 3 came off of the shaft.
If anyone can help I would be extremely grateful 🙏
-