Factory UTV Can Am Maverick and Maverick Max Longhorn Bumper
-
Similar Topics
-
By dj9800
Went to pull the front axle on a buddy's prowler today,after finding a ripped boot.but the axle had other things in mind,and the shaft came out of the coupler that goes into the diff,I've beat the hell out of it and pryed at it and she won't come out,not even the slide hammer will do it.what should I do?
I will get some pictures later
-
By Dirt Road Adventures
Hello my name is Andy Seddelmeyer and I am from Decatur Indiana. I own a Honda Talon X4. I am also the owner of Dirt Road Design.
I make accessories for SXS's but not limited to Honda. dirtroaddesignllc.com is the website if you would like to check it out.
-
By Rey Ximenes
OK, here's the mystery of the day. I was using the UTV the other day and the idiot light came on that said it was overheating. I immediately shut down and checked the coolant. No coolant! I refilled the overflow reservoir and the radiator and all was fine. 2 days later the light is on again. I rechecked the radiator and it was again empty? Bone dry? Now, here's the weird part, There is no coolant anywhere on the floor below the vehicle. I can't even see any on the frame. I have it up on the lift and am getting ready to start tearing into the bottom "skid plate" to see if the leak is in the hoses there. Any suggestions as to where to start? I have yet to begin and I am already baffled!
-
By cliffyk
I had mentioned in a previous post that I had removed the front anti-roll bar from my 2020 Outfitter 400; I ran that way for a month or so without noticing any downside however recently I installed a 'suicide knob" (see below) to assist my Parkinson's disease affected arms in turning the beast--but after doing so i found that in the quicker, tighter turns the knob permitted the vehicle would nosedive a bit, dig in, and plow on hard surfaces--not scary, but quite noticeably.
So I put the bar back on. Then today I got about 1-1/2 miles down the main road on the nearby power lines, turned around and came home to take it off--with the bar on, at 25 to 30 MPH, the front-end of the beast jumped like rabbit at each bump in either wheel rut., for a nearly brutal and quite uncomfortable ride. the bar (20 mm solid steel) is far too robust for the weight of the vehicle. The front bar on my 3900 lb. Infinity M37 is 30 mm...
suicide knob--for you younger folks:
-
By johnpeter
2022 Polaris RZR Pro XP Ultimate Rockford Fosgate edition like new On Ebay
https://www.ebay.com/itm/165963318931?
-
-
-
Gallery Images
![render[2].jpg](https://www.utvboard.com/uploads/1266430190/sml_gallery_475_29_20648.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.