Eman85

It's a 2018 shows 78 mi. but there's been someone under the hood. Old guy, even older than me and I'm old, had it and didn't use it much parked in the garage. Think owner before him was a little rough on it. They installed a fuel filter inline and there's some replaced non original bolts on the clutch cover. Someone has had the fan cover off also. otherwise it's all in working order. Steering wheel is crooked I'm going to do an alignment and see if I can get it straight adjusting the tie rods. Wasn't sure if the steering wheel was splined and maybe off a tooth or so.

Fuel's not a problem, local station sells Rec gas 90 octane non ethanol. I've read where a lot of people use Rotella 15w-40, that would be easy as I buy it for my diesels in 5 gal buckets. I have run it down the road but it will mostly be used riding around my property for chores.

Any spec for head bolts? It has some top end noise I need to pull the side cover for the cam and check the chain. I was hoping it was just the valves noisey but I set them and it still has a rattle. Runs good and starts instantly.

I'm new to these units, but been working on cars trucks and motorcycles for over 50 years. I'd pull the injector and point it at a coffee can or such and spin the motor over and see what the stream is like. probably clogged worth buying a new injector and installing a fuel filter.

Thanks for the reply. It runs good now, I changed the injector, fuel filter and spark plug. Set the valves and out fresh gas in it. I found some FB pages with some action. This forum is pretty dead it appears.

Thanks for the reply. I was hoping the forum was more active with experienced owners and techs.

I have been searching and can't find much info on these units. Pretty surprising as every other thing I own I find a lot of info on. Researching for tech info and such it's like no one owns any of these yet I see them everywhere.

Pulled fuel injector to see if I could clean it or if it's stuck open. Had a slide on clip that was really tough to get off. Don't see how the clip is supposed to lock into the plastic part that the injector slides into. Any videos or pics of injector replacement?

I just purchased a Massimo MSU500 and no manual came with it so I have some questions. looking for part #'s and availability of basics like spark plug air and fuel filter. What is the valve adjustment specifications? Is there a fuel drain? It's been sitting, low mileage but I want to drain out the old fuel and put fresh.