-
Similar Topics
-
By Roadstar515
Just wondering if mine is the only one that’s seems very loud while driving. It just seems louder that other brands I’m use to. I guess you get what you pay for I’m assuming.
Regards, Rick
-
By Steve Vanvelzen
I have a 2021 Massimo T-Boss 550 which now has a crack in the rear gearcase. A few weeks ago during my usual fluid checks I noticed that the gear oil was very low and there was an oil film on the outside of the case on the side where the plug is. I topped up and cleaned it up. I assumed the the bolt was not sealing properly so I ran it as usual and same thing again and again. So then I was thinking that maybe I need a new washer or something. I cleaned the outside of the casing and was about to top up the oil when low and behold.......I noticed a crack across the top right side. OMG, this thing is only a year old. Any ideas out there on how this would happen and most importantly....how can I fix it?
Any advice would be appreciated because as we all know on this forum it is hard to get shops to work on these wonderful machines. And if I need parts, wish me the best of luck.
-
By Daniel Goodwin
Hi,
I have a brand new Hisun Sector E1 that I got in March-April timeframe. Its got about 100 miles on it. I was driving it yesterday among some tall grass on one of my hills when it just complete stopped moving. Pressing the accelerator and nothing. I put it in reverse, nothing. I tried in 2 wheel and 4 wheel drive, locked and unlocked. Nothing. I put it in neutral, turned the ignition off and started it again and was able to drive forward about 20-30 feet and it stopped again. No errors. No 45C message, nothing. Just completely unresponsive. I had to "limp" all the way home by turning it on and off to get home. That 30 feet or so that it would travel was full power, I could push it hard or take it gently and it would still cut out on me. Its super bizarre. Anyone have any ideas what might be going on? I'm no electrician...I thought buying a sector E1 would require less work from me than an ICE vehicle, it appears I was wrong. I'm 2 hours from the nearest distributor so pretty worried about getting it serviced.
-
By Hisun .500
So my hisun 500 is tore up and all the wiring is wasted i was wondering can i pull out all the wiring and just put in the. Basics .please help
-
.thumb.jpg.080f7ba3deabf170051987f7b5514b04.jpg)
By RickinMT
I'm still in the break in period and this thing is vacuuming up all the dust in the world. I had sealed up my old one pretty good but this one, wow. Looking to hear some input on where to duct-tape and seal, and what you guys use for same. I blew it out today with my compressor and I'm sure I should check the air filter already. Only 9 hours on it but I bet it's bad. I'll be adding soundproofing materials as a winter project, like I did on the old one, and that's when I'll have all the plastic under-seat panels out, so I'll be able to seal up everywhere I can.
The other question is, do I run the risk of trapping too much heat if I do too good a job? How critical is the air intake behind the driver's seat for the belt cooling duct? Should I extend the duct out somewhere? I have the dust/heat shield on it, the one that stretches behind the seats and comes up behind to deflect dust out back. It doesn't seal the under-seat areas very well, though.
Anyway. TIA.
-
-
-
Gallery Images
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.