Quantcast
Jump to content


Replacing rear axle 06 commando


Recommended Posts

The old axle came out without much trouble. I installed the new one. After driving it around some I noticed some rear end grease leaking from the diff. There is a gap between the inner cv and the diff now that I didn't notice before. I can't get the axle to go in any farther or I can't get it to come back out. Any ideas or suggestions?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By BernieG
      I could really use some help identifying some disconnected components on a Yard Sport YS400. The first part is this pipe, which comes out of the exhaust port area or the cylinder. It looks like it had a piece of rubber hose on it, but the hose is gone, and I have no idea what it was previously connected to.

      The second item is this vacuum valve looking thing.  Again only one line is still attached.  What is it's function and what other lines should be connected to it?

      The last thing is this hose, which exits the side top of the fuel tank (not the fuel line hose) but is not connected to anything

       
      Any help the community could provide would be greatly appreciated.  This UTV belongs to a friend, and I am trying to help him get it running correctly for his kids.
    • By Retired Plumber
      The rear differential lock light is on and I would like to get it off. How do I do that it is a Coleman UTV700.
    • By djl
      Hi All.  The splines are pretty well worn where the rear driveshaft fits into the adapter (boss?) on the rear of the engine.  I have a new driveshaft / adapter / seal to install but am having difficulty loosening the nut holding the adapter onto the transmission output shaft.  I purchased a chain-type vice grip tool thinking that I could get it around the adapter to prevent it from turning but have not had any luck getting it in there yet (very tight space).  What approaches have you used that have worked?  Thanks!
    • By Anthony Vigil
      Can anyone tell me how they grease the drivelines ?  Can’t grease the u joints. Do you need to take the driveline off ? 
      And are they easy to take off?
      Thanks
    • By donny
      Hey everyone new to forum I have a 2014 Odes raider and a 2009 Suzuki Ozark 250 both down atm 😔
×
×
  • Create New...