Quantcast
Jump to content


Recommended Posts

Posted

I seen a razor 800 with Suzuki samurai axels and transfer case..it got me thinking about doing it my trooper..there cheap and a great 4 link setup.. may even rear hydro steering too.. just a thought... wondering what you all thought about it..???

 

 

Sent from my iPhone using Tapatalk

  • Travis featured this topic
Posted

Lol, of course I have.  That's why I have a suzuki samurai parts car sitting in my yard.  I was planning on starting with a transfer case install. I am also thinking about a rear axle install only with front ifs, but matching gearing will be tough.  If you go full solid axle you WILL miss the ride of the independent suspension. 

  • 4 weeks later...
Posted
Lol, of course I have.  That's why I have a suzuki samurai parts car sitting in my yard.  I was planning on starting with a transfer case install. I am also thinking about a rear axle install only with front ifs, but matching gearing will be tough.  If you go full solid axle you WILL miss the ride of the independent suspension. 





Sent from my iPhone using Tapatalk

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Karlibob
      I have a 2020 800 sx with about 16 hours on it.  From day one I have heard a clunking noise from the front end going over bumps.  Has anyone else experienced this?  Also this past weekend while out riding I heard a noise that sounded like the dump bed bounced three or four different times, again has anyone experienced anything like that.  Thanks, gary
    • By Marie
      Hello, we recently got a 2013 Hisun 800 as a little project for my husband and I to work on. Turns out the guys before us loved the mud anyway. We have replaced the stator and now going to do the Rectifier but here is the hold up as seen in the picture. There are tons of wires going to the battery. I cant seem to find anything that shows what wires should, or shouldn't be attached to the battery or where these 2 plugs go. if someone would please take some pics or share knowledge to where they go I would appreciate it greatly.
    • By Marie
      hello, i need help figuring out where all these wires go on this battery. I can't seem to find any pictures diagrams. As to what should or shouldn't be attached and where these two plugs go, that aren't plugged in. this was got as a project. would run then die and battery would have to be jumped off to start again stator has now been replaced but any help with this wiring would be appreciated. 
    • By A P
      Hi
      I have a 2022 hisun sector eps 550. 30amp fuse is blown for eps. Checked the motor and it’s fine. Opened up the controller and found a bad diode. Dealer wanted 500$ for the controller. Just posting this in case it helps someone. I couldn’t read numbers from the old one so just took a guess and replaced it with a 100v 3amp diode. 
    • By SteveS
      While driving the MSU 800, it runs good but it lately it will not go over 20 MPH. The side by side will hesitate when it reaches 21 MPH, but it will run good under 20 MPH. What is the issue?
×
×
  • Create New...