Don’t waste your time everybody with rpm motorsports, Omaha. They are people that don’t even work on sxs’s. Trying to tell you how to install things.
Completely uneducated guy tried to tell me I did not install a mid pipe correctly when it won’t install correctly; that was the reason for the video and the complaint that I called him about.
This mid pipe has a 1 inch gap at the rear, and the only way to close it up is with a longer bolt, and to stretch the flex at the Exhaust
After one ride, the rear bolts have disappeared, because how much tension there is on the flex
And the bolts does not line up at the flange
Have a video before and after. And they are telling me that it’s my fault because it does not fit
What kind of idiotic people are even answering the phones these days.?
This guy has probably only read a book and never even driven a motorcycle in his life
Don’t waste your time with this bullshit products
By joey mccarty
I have replaced the ignition coil, spark plug, injector, fuel filter, map sensor, iac sensor, checked fuel pump and it still acts like it wants to cut out when my revs are over 3100 rpms. the problem is intermittent but happens frequently and i dont want to leave my hisun at a dealer 100 miles away and wait months. It never stalls but it idles rough and sometimes when its real bad i cant go over 10 mph. yes i fasten seat belts
By Jon Spruill
Hey Guys, I have been chasing a stalling condition for about two weeks now. The bike will crank up and idle fine, then after about 20 seconds it will fall on its face and stall. It happens at both idle and while running at various rpms. You can turn the key off, turn it back on and it will fire right back up without trouble. I have verified spark on both cylinders with a spark tester. I have also added an inline fuel filter, and pulled the injectors to verify proper pulse on each. Things I have replaced - (relearn procedure performed after each component replaced): spark plugs, ECU, relay/fuse box, fuel pump, & throttle position sensor - all with no improvement of the condition. The only warning light I get when the condition occurs is the oil lamp. The bike only has 14 miles. I am at a loss and appreciate any help and suggestions! Thanks
By Randy Mullenberg
Hello I have a 2014 Polaris Ranger that all of the sudden won’t stay running. It fires immediately but shuts down in about 3 seconds. Checked all the obvious, oil, air filter, gas in tank, fuses, fuel lines and even changed fuel pump. Any other ideas?.