-
Similar Topics
-
By Texas Rider
Okay guys, this Vector 500 is killing me. Hisun 500cc engine (Chinese) About a year ago while riding slowly, I heard a tink and UTV turned off and would not start. Checked everything long story short, timing chain jumped off lower sprocket, slightly bent the cam sprocket phasers. Bought new chain and cam sprocket, set everything back to timing position, mounted chain on lower shaft sprocket and upper cam sprocket. Set the tensioner, cranked and poof, chain once again jumped off lower shaft sprocket. Again, repeated proper timing settings, remounted chain, cranked and poof again and again and again, chain keeps jumping off lower sprocket. Just to be clear, valves, piston and all components are look in great condition. Can't see shaft sprocket but to the finger behind the tight squeeze, all sprockets seem to be in place, or maybe not. Tired of fiddling with it. This was bought brand new at Home Depot and has less than 200 hrs in the past 3 years. Don't tell me to warranty it as that expired one year in. Talked manufacture out of McKinney TX and service tech was no help. My question to you, what am I missing? What next?
Dumbfounded 🤔
-
By Retired Plumber
The rear differential lock light is on and I would like to get it off. How do I do that it is a Coleman UTV700.
-
By djl
Hi All. The splines are pretty well worn where the rear driveshaft fits into the adapter (boss?) on the rear of the engine. I have a new driveshaft / adapter / seal to install but am having difficulty loosening the nut holding the adapter onto the transmission output shaft. I purchased a chain-type vice grip tool thinking that I could get it around the adapter to prevent it from turning but have not had any luck getting it in there yet (very tight space). What approaches have you used that have worked? Thanks!
-
By kgs
Got a hisun sector 550 2019 that's got 5900 Miles on it, this year it started to getting hard to start in morning, once I get it started it works good the rest of the day. But to start it in the morning I got to hold the gas pedal to the floor and it will fire up. I replaced the fuel injector but didn't help it. So I just ordered a new air filter and 02 sensor and a maf sensor to put on it to see if this will fix it. Anyone else had this problem. I'm hoping the parts I ordered will fix it. I also bought a new battery to put in it also.
-
By packersfan
I have a hisun 500 got from a auction and when turning a corner left or right it's a two hand job then when you left go snaps back.any help on what to look at would be appreciated.
Also blows blue smoke until she gets warm then it's ok
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.