I have a 99 kawasaki mule 550 kaf300c3 That I ordered new valve guides for. Problem is my valves don't fit in new valve guides. Part number is correct.
Is it possible that valve guides need to be installed and reamed before the valves will fit into the guides? Just seems like an awful lot of material to have to remove by reaming.
Thanks for any help
By Kirk Falk
I have a 2018 Dominator LT 1000 and I am wanting to stiffen up the ride. What is the best way to accomplish this, tighten the recoil spring up or add air to the shock. I can't find any information on the procedure. Also, since im asking questions........my top end rpms doesnt seem to be where it should be. Max RPM is 6100 and usually drops down to 5800 maxed out. Im just wondering if everyone else has the same experience.
By Joel Goldsney
2009 Hisun 700.... previous owner did a number of changes. This part is under the driver's seat but not attached to anything.
Is this the old fuel pump?