Quantcast
Jump to content


Recommended Posts

Posted

So my 2022 landmaster l7x while driving for a little while will cut out and go to idle even with my foot down on the gas.  It will kick back for a couple of seconds then go back to idle.  I have to shut it off for awhile before it will let me drive for about another minute or 2 then the same thing.  It never Boggs down down or acts like it want to die.  Just jumps to idle.  I’m not sure what the problem can be.  New air filter, file filter and oil change recently 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By techmech92
      The company I work for bought 4 Landmaster L4's. They have been here for about a year; I am the tech that works on them. One started bogging down under anything over half throttle, I checked everything I possibly could think to check before finally breaking the engine down and find that the intake cam was worn almost completely to no lobe at all. Last week another unit started running poorly until the throttle no longer responds. I can't seem to find anything that would make this happen, I am working on having the company obtain a tiny scan to be able to access any fault codes, but so far everything electrical seems to be doing what it should be. They both have the Vanguard engine. Any tips to figuring out the one, and tips or tricks to help me keep the other running?
       
      Thank you for your time.
    • By Silent3923
      Been waiting over a month and a half for a transmission from bobcat,  they claim the polaris transmission is different.   Can anyone verify that???
    • By Nick Varnes
      So I have a Bennche Bighorn 500 that I bought used a couple years ago. Was working fine until this winter when I was plowing and I think it drained the battery. And had a difficult time starting and staying running. Idle seamed really low, and would only stay running if I pushed on the throttle. So I changed the battery, and the acm valve, fuel filter and spark plug it will start up and surgery to 3k rpm but comes back down and dies, unless I give it throttle. I am getting fairly good amount of fuel from fuel pump.  It does spit at stutter right before it dies. What should I try next?
    • By BWF
      I have a 2011 or so Landmaster LM200.  I cannot get it to start.  I turn the key and nothing happens.  The brake switch seems to be working, the ignition switch works.  The Coil is new the Voltage Regulator is new and the starter relay is new.
       
      I can connect the terminals on the starter relay and it starts right up and runs fine.  I just can't get it to start by turning the key.
       
      I am having a bit of trouble bleeding the brakes, not much fluid comes out at the calipers when I am pumping the brakes, though that an air bubble near the brake switch might make it not sense that the brake pedal is depressed.
       
      I am at a loss, please help!
       
      Brad
    • By Fmaxiron
      I just purchased a 2023 Honda Pioneer a couple of weeks ago and had the hard roof and a front Honda Pioneer windshield installed at the shop before taking ownership. As things are drying up here in NC, the grass and dust are beginning to fly right through the back of the cab while driving. I was wondering if anyone has any good recommendations on rear windshields, dust panels, or mesh screens to help stop this?
      Thanks a lot!
×
×
  • Create New...