Quantcast
Jump to content


Recommended Posts

Posted

New member from Central Texas. Have a 2013 Mule. Found this forum cause I have an issue with gas in the crankcase oil. Hope I can find a remedy on the forum. 
Thanks

Ricky

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By itzaphatlife
      Just acquired a 2009 Joyner Trooper t4 1100 with roof rack and dump bed , as I live in North East Montana (60 miles from Canadian border) it gets mighty Flippin cold here , I need to come up with a cab enclosure quick , and preferably one that won't cost me more than I can really afford ... that being said , I'm a 53 yr old female Wyotech Off road powersports grad , and am willing to take on a diy with my fiance , he's a current mechanic , I'm disabled but can still do quite a bit so I'm here to learn as much as I can !! All the help , info , ideas , products , etc.  You can throw at me I will truly appreciate !! Thanks in advance and super glad to be a part of this community !!

    • By Silent3923
      Been waiting over a month and a half for a transmission from bobcat,  they claim the polaris transmission is different.   Can anyone verify that???
    • By rdc
      I have a 2007 Joyner 1100 sand viper and  before it even get's to where the thermostat opens up the oil pressure get's so low I have to shut it down. What could fix this ? I thought about adding an oil cooler with fan, thicker oil, or removing the thermostat. Any advice?
    • By dilger
      Transmission vent leaks oil out of it after using 
    • By OBL
      program will open in old Bud program only/ but will not go in BUDS 2 to let use program ECU problem working on has new engine/ new fuel pump/ injectors/ lines/ sensors/ crank sensor maps/ and new throttle body and injectors. machine starts runs a minute dies/ on 3 rd  try says key not recognized /we put other key in and same thing happens/wait 10 minutes, you can go again/ is there a back door in the program/ also might mention unplug temp sensor and map sensor , it will run a few minutes longer / then die again.
×
×
  • Create New...